DynaColor DG80II Manuale di configurazione - Pagina 8

Sfoglia online o scarica il pdf Manuale di configurazione per DVR DynaColor DG80II. DynaColor DG80II 14. Versatile h.264 dvr

Dome Camera Control

Dome Camera Connection & Settings:

 See section Pin Definition of Alarm I/O & RS-485, and Audio In for RS-485 port pin definition.

 Refer to the following figure. Connect the R+, R- terminals on the dome camera to the D+, D-

terminals on the RS-485 port by RS-485 cable respectively.

 To set up dome camera's protocol and ID, press MENU to access the OSD main menu, and

select <Camera Setup>. Then select <Dome Protocol> and choose the corresponding

protocol. Next select <Dome ID> and choose a preferred ID number. Note that the ID number

must match the ID address defined by the dome camera.

 To configure the RS-485 parameters, select <System Setup> from OSD main menu, and then

select <RS485 Setup>. The default RS-485 settings are 9600 Baud, 8 Data Bits, 1 Stop Bit and

No Parity.

Control Buttons in Dome Camera Control Mode:

Iris Close

Iris Open

Focus Far

Focus Near

Zoom In

Zoom Out

Enter Dome Camera

Control Mode

ESC

Set / Go Preset

Go Presets 1~6

Pan / Tilt

Enter / Auto