DynaColor EDNS V3000 Manuale di configurazione - Pagina 4

Sfoglia online o scarica il pdf Manuale di configurazione per DVR DynaColor EDNS V3000. DynaColor EDNS V3000 14.

Install HDDs (Plus Models Only)

For Plus Models, users can install up to 4 HDDs to create a preferred RAID disk type. Note the

SATA port numbers on the SATA board (as shown in below figure) are linked to the indication

numbers in the OSD menu.The installed HDDs must be the same storage capacity, and it is strongly

recommended to use HDDs of the same model. Please refer to the following steps to install HDDs

into the DVR.

NOTE: Please avoid using Seagate SV35 series and WD AVGP series HDDs.

 Release the screws and remove the cover of the Ernitec EDNS V3000.

 First fix the HDDs onto the mounting kits. Then connect the power and SATA cables to the HDDs

and fix the HDDs onto the bottom of the DVR.

 Connect the SATA cables to the SATA ports on the SATA board.

 Put the cover back to the DVR and connect the power cord and required equipments.

For users who are not familiar with RAID disk types, please read the next section about facts of

different RAID disk types BEFORE creating the RAID disk in the DVR.