7SenseTech Hawk 4K Manuale d'uso - Pagina 9

Sfoglia online o scarica il pdf Manuale d'uso per Accessori per droni e quadcopter 7SenseTech Hawk 4K. 7SenseTech Hawk 4K 10.

Stampa la pagina

Flight Modes

Code Binding

The drone, watch and tracker are all linked by default initially. Here is the

trick about code binding just in case that those devices are new to each

other.

Drone to watch: Plug a small connector into two short needles on the

gimbal mount to make a short circuit. Power the drone and immediately

remove the connector. Then press the power button and backward button

of watch at the same time and hold them for a few seconds while the

watch is binding the code of the drone. The watch will get connected

with the drone when the screen shows the control interface.

Disconnect

Code Binding

Watch to GPS tracker：Turn on the watch and GPS tracker. Insert a needle

into a hole on the tracker's back. The blue LED will start to flash blue. The

tracker will get connected to the watch when the LED is steady on and the

follow GPS signals on the watch show 0.

Follow Tracker

Signal connected

Disconnect

Connection distance less than 1 meter

(Please take it by your side)

Press and hold the power button and

backward button to start code binding.

Bind code ... 0

Hawk 4K

Bind code Begin

NET ID:XXX

Watch

Disconnect

Preparations Pre-fly

1. Place the drone on a flat platform and turn on the battery by pressing

& holding the power button on the tail. The drone will immediately start

self-checking when the front red LEDs lights and rear blue LEDs start

flashing quickly.

2. When the blue LED slowly flashes and the aircraft gives out a Di-Di

sound, it indicates the checking of fly control system is completed.

3. When the gimbal is level and the aircraft gives out another Di-Di sound,

it indicates that the gimbal is ready.

4. Turn on the watch by pressing & holding the power button on the top.

In a few seconds the watch will get connected to the aircraft when the

screen shows the control interface. Wait until the drone gets at least 10

gps satellites and an icon of "

"shows on the watch before take-off. If

the satellites are weak or unstable, try it at another place. To turn off the

watch, also press & hold the power button.

5. Turn on the GPS tracker by pushing the button on the top, wait until 7

satellites are collected and an icon of "

starting follow me flight.

Notes: If drone receives no instruction for 10 minutes while powered on, it will emit an alarm

sound, which is normal. You could either unlock the motors or turn off the battery to stop that

sound and then try starting again.

Flight Modes

" shows on the watch before