GREAT PLANES Dazzler ARF Manuale di istruzioni - Pagina 10

Sfoglia online o scarica il pdf Manuale di istruzioni per Giocattolo GREAT PLANES Dazzler ARF. GREAT PLANES Dazzler ARF 20.

5. Cut a piece of foam the size of the bottom of the fuel

tank. Place this foam inside the fuel tank compartment. Then

insert the tank into the fuel tank compartment.

6. Attach a piece of silicone fuel tubing to each of the fuel

tank fittings. Pass the lines through the hole in the firewall.

Connect the lines to the engine. The line attached to the fuel

clunk attaches to the carburetor and the other to the pressure

fitting on the muffler. Note: Refer to the sketch at Step 3 to

see exact fuel line connection.

7. Cut another piece of foam and place it on top of the fuel

tank, then reinstall the fuel compartment hatch to the fuselage.

RADIO INSTALLATION

1. Cut away the covering in the wing to reveal the openings

for the two servos as shown in the above photograph.

2. Trial fit the servo tray into the opening in the bottom of

the wing. It should fit between the rib in each half of the wing.

Trim the tray as needed to fit into the wing.

2. Measure down from the surface of the wing 5/8"

[15.9mm]. On that mark draw a line that is parallel to the

bottom of the wing. Do this on the rib on both the right and

left wing panel.

3. Locate the two hardwood landing gear rails. Using

6-minute epoxy, glue the rails in place on the bottom of the

lines you have drawn.

4. After the glue has cured, glue the servo tray to the rails

with 6-minute epoxy. Be sure the side by side servo openings

in the tray match up with the two servo cutouts in the wing.

5. Install a 6" [150mm] servo extension onto the end of

two servos. (Hint: Tape the connectors together to insure the

extension does not unplug from the servo.)

6. Install one servo into the aileron servo bay in the

right wing, feeding the servo wire through the wing ribs,

exiting into the radio compartment.

7. Drill four 1/16" [1.6mm] holes in the servo mounting

tray for the servo screws. Note: Installing the screws without

drilling the holes may result in the plywood servo tray splitting.