HiB 79520000 Manuale

Sfoglia online o scarica il pdf Manuale per Prodotti per la cura della persona HiB 79520000. HiB 79520000 2.
Anche per HiB 79520000: Istruzioni per l'uso (2 pagine)

Stampa la pagina
This product is suitable for installation in zones:
&
2
Outside Zone
All installations must comply with guidelines which are based on a zonal
concept. The diagram above illustrates this concept and must be followed
to ensure the safe installation of electrical appliances in the bathroom.
These regulations apply to domestic installations only. Installations must be
made in accordance with the current IEE wiring regulations and relevant
building regulations. HiB recommends that all electrical bathroom
products should only be fitted by a suitably qualified, Part P registered
electrician.
Installation
Ensure the domestic electrical mains supply to which the mirror
is being connected is turned off.
1. Position the mirror in a suitable location (according to the zonal
diagram - Fig. 1), ensuring that the domestic electrical mains
supply is within reach of the cable connection point of the
product.
2. Carefully mark the position of the mirror using a soft pencil
ensuring it is level. Remove the mirror and mark the mounting
points (see Fig. A) Please ensure that all marked mounting
points accurately match up with the fixing points on the
mirror.
3. Using a suitable drill bit, drill holes in the marked positions to a
suitable depth. If drilling through tile, use a ceramic drill bit.
4. Insert wall plugs level with the surface of the wall. If fitting to a
tiled surface, wall plugs should be inserted below the tile surface
to avoid cracking. NB. For plasterboard walls, specialist fixings
should be purchased, available from any DIY or hardware store.
5. Screw supplied fixings into wall plugs.
6. Connect the domestic mains supply to the terminal box according
to the wiring diagram opposite (Fig. B).
7. Hang the mirror in position.
8. Switch the domestic electrical mains supply for the mirror back
on.
WEEE compliance
Must not be mixed with general household waste
T:
+44 (0)20 8441 0352
F:
+44 (0)20 8441 0219
Building 3, North London Business Park, Oakleigh Road South, New Southgate, London. N11 1GN
©HiB Copyright: No part of this document may be reprinted or duplicated without HiB consent. All sizes and measurements are approximate, but we do try and make sure they are as accurate as possible. In the
interest of continuous product development, HiB reserves the right to alter specifications as necessary. E & OE.
Illuminated Mirrors
Spectre 50
Spectre 100
Thank you for purchasing this HiB product.
Please read through these instructions carefully and refer back to them
during installation to ensure that your product is fitted safely and that it
retains its high quality finish.
Please retain this leaflet for future reference.
Before installation, ensure the domestic electrical mains supply to
which the mirror is to be connected is turned off. Before drilling,
(Fig. 1)
ensure that there are no hidden cables or pipes in the wall.
Mounting Points Diagram (Fig. A)
Operation Instructions
To turn illumination on touch the sensor once.
To change the colour temperature, touch and hold the sensor until
desired colour is obtained. The colour temp is then set until changed
again.
Heated Pad is only on when mirror is illuminated.
Care Instructions
Do not use abrasives or solvents when cleaning this product.
Wipe off all water spillages as soon as possible using a soft, damp cloth.
Aftercare Service
In the unlikely event that this product should fail please contact HiB
customer services, details shown below.
E:
hib.co.uk
Art No. 79510000
Spectre 60
Art No. 79530000
Hanging Landscape
REAR VIEW
mounting points
ONLY Spectre 60 can be hung either
portrait or landscape
FI#01 018 R161104
Art No. 79520000
Ver No.
1.0 Jan 2017