GREAT PLANES Spirit 100 Manuale di istruzioni - Pagina 15

Sfoglia online o scarica il pdf Manuale di istruzioni per Giocattolo GREAT PLANES Spirit 100. GREAT PLANES Spirit 100 20.

❏

2. Connect the wing servos and, if used, the spoiler hooks

to the loop end of the spoiler activation rod. The spoiler cables

will need to be pulled slightly to reach the loop on the wire. Be

careful no to over-extend the spoilers by pulling too hard on

the cable. Mount the wing with the four 6-32 x 3/4" [19mm]

SHCS and washers.

❏

3. Tape the canopy to the opposite side of the fuse from

the battery.

❏

4. Accurately mark the balance point on the bottom of the

wing on both sides of the fuselage. Use thin strips of tape or

a felt-tip pen to make the marks. The balance point (CG) is

located 4-1/2" [115mm] back from the LE where the wing

meets the fuse. This is the balance point at which the model

should balance for your first flights. After initial trim flights you

may wish to experiment by shifting the balance up to 1/4"

[6mm] forward or back to change the flying characteristics.

❏

5. Mix small amounts of the steel shot with epoxy and

pour it into the nose of the plane to set the CG.

❏

6. After the epoxy has cured and the CG is confirmed

install the battery in the fuse.

4-1/2" [115mm]

Mount the Canopy and Tow Hook

❏

1. Use needle nose pliers to open up the canopy hook so

there is a 1/16" [1.6mm] gap.

❏

2. Drill a 3/64" [1.2mm] hole through the back of the

canopy. Screw the canopy hook into the canopy and secure

it with thin CA.

❏

3. Attach a small rubber band to the fiberglass support at

the end of the hatch.

❏

4. Loop the rubber band over the canopy hook. Slide the

canopy in place.