GREAT PLANES XPD-8 Manuale di istruzioni - Pagina 10

Sfoglia online o scarica il pdf Manuale di istruzioni per Giocattolo GREAT PLANES XPD-8. GREAT PLANES XPD-8 16.

❏

6. Cut a slit at the marks on the elevons 1/4" [6mm] long

5/16" [8mm] from the leading edge of the elevons. Enlarge the

lowest hole in the elevon control horns with a 3/64" [1.2mm]

drill bit. Insert the control horns into the slits in the elevons.

❏

7. Press the control horn backplates over the tabs on the tops

of the elevons. Add a couple of drops of foam-safe CA glue to

secure the backplates to the tabs and to the elevons.Trim off the

excess control horn tabs protruding above the backplates.

❏

8. Locate the two 2-3/4" [70mm] Z-bend pushrods and

connect them to the outer holes in the elevon servo horns.

Connect the 2-3/4" [70mm] 90° pushrods to the lowest holes

in the elevon control horns and secure each one with a 90°

pushrod connector.

❏

9. Slide a 1" [25mm] piece of heat-shrink tubing onto one

of the pushrods. Overlap the pushrod ends and join them

together with the heat-shrink tubing.

❏

10. While holding the elevons in the neutral position,

carefully use a soldering iron to shrink the tubing around the

pushrod ends. Do this by moving the iron tip back and forth

quickly across the tubing until it has shrunk tight on the

pushrods. Do not use a heat gun or micro torch to shrink

the tubing as it will melt the foam near the pushrods.

Add a drop of CA glue to each end of the tubing to secure it

to the pushrods.

Install the Electronics

The instructions that follow are written to accommodate the

Futaba R114F receiver, Great Planes 11.1V 910mAh LiPo

battery pack, and Great Planes C-25 ESC. Other brand

receivers and battery packs may fit, but you will need to

confirm that the canopy top secures properly onto the fuse

with the equipment installed.

❏

1. Cut a piece of hook and loop material to a length of

4-1/4" [108mm].