HiB Solas 50-C Manuale di avvio rapido

Sfoglia online o scarica il pdf Manuale di avvio rapido per Prodotti per la cura della persona HiB Solas 50-C. HiB Solas 50-C 2.

Stampa la pagina

This product is IP44 rated and suitable for installation in

zones:

Outside Zone

All installations must comply with guidelines which are based on a zonal

concept. The diagram above illustrates this concept and must be followed

to ensure the safe installation of electrical appliances in the bathroom.

These regulations apply to domestic installations only. Installations must be

made in accordance with the current IEE wiring regulations and relevant

building regulations. HiB recommends that all electrical bathroom

products should only be fitted by a suitably qualified, Part P registered

electrician.

Thank you for purchasing this HiB product.

Please read through these instructions carefully and refer back to them during

installation to ensure that your product is fitted safely and that it retains its

high quality finish.

Please retain this leaflet for future reference.

Before installation, ensure the domestic electrical mains supply to which

the mirror is to be connected is turned off. Before drilling, ensure that

there are no hidden cables or pipes in the wall.

CAUTION

Caution

We recommend that you place this mirror on a soft flat surface to ensure no

breakages. We also recommend that you leave corner protectors on until

Do not lift this product via the illuminated frame

+44 (0)20 8441 0352

+44 (0)20 8441 0219

Building 3, North London Business Park, Oakleigh Road South, New Southgate, London. N11 1GN

©HiB Copyright: No part of this document may be reprinted or duplicated without HiB consent. All sizes and measurements are approximate, but we do try and make sure they are as accurate as possible. In the

interest of continuous product development, HiB reserves the right to alter specifications as necessary. E & OE.

final fitting.

[email protected]

Illuminated Mirrors

Solas 50-C

Art No. 79510500

Solas 50-B

Art No. 79520500

Installation

NB. SOLAS mirrors must be installed with a minimum distance of 150mm

between the infra-red sensor switch and any adjacent wall or object to

ensure correct operation of the sensor.

1. Position the mirror in a suitable location (according to the zonal

(Fig. 1)

diagram - Fig. 1), ensuring that the domestic electrical mains supply

is within reach of the electrical entry point of the product.

2. Carefully mark the position of the mirror using a soft pencil

ensuring it is level. Remove the mirror and mark the mounting

points. Please ensure that all marked mounting points

accurately match up with the fixing points on the mirror.

3. Using a suitable drill bit, drill holes in the marked positions to a

suitable depth. If drilling through tile, use a ceramic drill bit.

4. Insert wall plugs level with the surface of the wall. If fitting to a tiled

surface, wall plugs should be inserted below the tile surface to

avoid cracking. NB. For plasterboard walls, specialist fixings should

be purchased, available from any DIY or hardware store.

5. Screw supplied fixings into wall plugs.

6. Ensure the domestic electrical mains supply to which the

mirror is being connected is turned off. Connect the domestic

mains supply to the terminal box according to the wiring diagram

(Fig. B) overleaf.

7. Hang the mirror in position.

8. Switch the domestic electrical mains supply for the mirror back on.

Mounting Points Diagram (Fig. A)

hib.co.uk

/ Solas 60-C

Art No. 79510600

/ Solas 60-B

Art No. 79520600

REAR VIEW

MOUNTING LOCATIONS

Note: Solas is dual orientation.

FI#01 024 R181005

Ver No.

1.0 Jan 2019