GREAT PLANES S.E.5a Manuale di istruzioni - Pagina 9

Sfoglia online o scarica il pdf Manuale di istruzioni per Aerei GREAT PLANES S.E.5a. GREAT PLANES S.E.5a 20.

❏

15. Remove the fin from the fuselage. Use a sharp #11

hobby knife or the "Expert Tip" on page 8 to cut the

covering from the fin just inside the lines you marked. Use

care to cut only the covering and not the wood. Cutting the

wood will weaken the fin and it may break in flight.

❏

16. Reinstall the fin and rudder. Check that everything is

aligned. Then, use thin CA to glue the fin in the fuselage.

Also use thin CA to glue the three CA hinges, centered in

the fin and rudder.

❏

17. Cut the covering from over the two tail skid mounting

holes on the bottom of the fuselage.

❏

18. Attach the tail skid to the bottom of the fuselage using

thin CA.

RADIO INSTALLATION

Install the Motor & ESC

Note: You will need to have your motor battery charged later in

this section. We recommend that you start charging it now so

you do not have to wait for it to charge later. Make sure to closely

follow the charging instructions for charging LiPo batteries.

❏

1. Cut a 20mm long piece of hook and loop material. Glue the

20mm soft piece (hook side) to the back of the ESC. Glue the

rough piece (loop side) to the top of the inside of the fuselage.

Insert the ESC through the front of the firewall. Route the battery

connector out of one of the two holes at the back of the battery

compartment. Route the servo lead into the wing opening and

the three motor leads out the front of the firewall. The reason the

ESC needs to be mounted in this location is so that it has a good

flow of air over it.

❏

2. Attach the RimFire motor to the back of the plywood motor

mount with three 3 x 6mm machine screws. Apply a drop of

threadlocker on the threads of the machine screws.