GREAT PLANES Tori Manuale di istruzioni - Pagina 6

Sfoglia online o scarica il pdf Manuale di istruzioni per Aerei GREAT PLANES Tori. GREAT PLANES Tori 20.

❏

2. Use an epoxy brush to apply a thin coat of epoxy or

medium CA to the inside of the top wing skin in the aileron

servo opening. Allow epoxy to harden before continuing.

❏

3. Tie the string in the wing around the end of the included

aileron servo extension as shown – a small drop of thin CA

will ensure that the knot doesn't come undone when you are

drawing the servo wire through the wing.

❏

4. Carefully pull the servo wire out as you pull the string.

❏

5. Guide the servo connector and the wire out the hole in

the bottom of the wing.

❏

6. Use medium-grit sandpaper to roughen the bottom

portion of the two larger control horns so glue will adhere.

Install a brass screw-lock connector into the top hole of

both horns and secure with a nylon retainer as shown. Be

certain the retainer snaps on securely. If the retainer fi ts

loose, replace it with another – four spares included.

❏

7. Cut and remove the covering from the bottom of the

aileron over the slots for the horns.

❏

8. Insert the horn into the aileron as shown (with the screw-

lock body on the outside of the horn toward the tip of the

wing), then use thin CA to securely glue the horn into place.

7/16" [11mm]

hole in Tactic

servo arm)

❏

9. Identify a hole in the servo arm that is 7/16" [11mm]

out from the center (this would be the 4

servos), or the next hole closest in. Use a #55 (.052" [1.3mm])

drill to enlarge the hole to fi t the aileron pushrod. Then, cut

off the rest of the servo arm so it will not interfere with the

servo hatch cover.

❏

10. Connect the aileron servo to the servo extension in

the wing.

Cut off

Trim

hole out for Tactic