HiB RadioStar acoustia Manuale di istruzioni - Pagina 4

Sfoglia online o scarica il pdf Manuale di istruzioni per Radio HiB RadioStar acoustia. HiB RadioStar acoustia 8.

Stampa la pagina

ASSEMBLY INSTRUCTIONS

1
- Remove the RadioStar Mirror, the
remote control and the fi xing kit from the
packaging.
- Carefully lay the mirror fl at on the
fl oor and check that the contents are
complete.
3
.88.88.
- Take off the mirror surface carefully and
place it fl at on a soft cloth to prevent
damage.
- Switch off the electrical fuses for the
area in which you are working.
2
- Remove the four screws at the sides or
top / bottom the mirror with a Phillips
screwdriver.
4
.88.88.
- Hold the steel casing to the wall in the
desired position.
- Adjust the position with the spirit level
to ensure that the mirror is straight.
- Mark the position of each of the fi xing
points with a pencil.
-
5
-
5
- Ensure that there are no electrical wires
or water pipes in the wall.
- Drill the holes using an 8mm drill bit at
the four marked positions.
- Insert the wall plugs.
7
- Connect the domestic power cable
to the electric terminal of the RadioStar
Mirror.
- Please use an insulated screwdriver.
RadioStar
6
.88.88.
- Make a hole in the rubber grommet
on the back of the casing for the power
cable.
- Lift the steel casing, pull the power
cable through the hole and screw the
steel casing to the wall.
8
- Replace the mirror surface and secure
it to the steel casing by tightening the
screws on the sides or top / bottom of
the mirror.
- Peel the protective fi lm from the mirror
and switch on the electrical fuses.
-
6
-