Great Wall X200 Manuale - Pagina 7

Sfoglia online o scarica il pdf Manuale per Elettronica per autoveicoli Great Wall X200. Great Wall X200 19. Keyless entry and immobilizer

X240 and X200 (H5) Programming (Face Lift)

Connect the Launch X431 to the vehicle and switch on the Ignition.

Power up the Launch X431 and select "Haval H5" then "BCM" and then (Select "K5 (N2)-BCM"

for X200 and "Delphi-BCM" for X240)

Select the "Key Teach" function. The following message will appear "please make sure you

want to teach key!". Press "OK" when you are ready to start.

Once the "Key Teach" function is selected, the message "The first key to start learning! Please

click the remote control transmitter button (Lock and Unlock buttons) 1 seconds. Begin match?

(Click "OK to start) will appear . Kindly ignore this message and just press "OK"

Once "OK" is pressed, the screen "It's executing, please wait..." will appear. When this

message appears, press and hold the lock and unlock buttons simultaneously on the remote

key until the message "Key Teach Success" appears (This can take anywhere from 3 to 8

seconds)

If programming a second key refer to the Note below.

NOTE: - When the X431 displays "learning the second key....." for another key remote to be

Matched

Some early versions of the X431 software and some early X240 vehicles will require you to press

the home button to exit the "Key Teach" function once the first key has been completed otherwise

you may delete the first remote. In this case you should back out to the "BCM" selection screen and

repeat steps 3 to 5 for the next key and both keys will then be learned.

With later versions of the X431 and later vehicles you can proceed when the X431 asks if you wish

to program a second key. Once this is done test the operation of the Key remote to ensure correct

operation (Ensure all doors including the tailgate are closed for this check).