Automatic Mirage M 801E Manuale - Pagina 2

Sfoglia online o scarica il pdf Manuale per Amplificatore Automatic Mirage M 801E. Automatic Mirage M 801E 17. Multi-zone digital amplifi er manual

Stampa la pagina

Important Safety Instructions

Do not use this device near water water

or expose to excessive moisture.

Clean only with a dry cloth.

Do not block any ventilation openings,

install in accordance with the manufac-

turer's instructions.

Do not install near any heat source such

as radiators, heat registers, stoves or

other devices (including amplifiers) that

produce heat.

Do not defeat the safety purpose of the

polarized or grounding type plug. If the

provided plug does not fit into your out-

let, consult an electrician for replacement

of the obsolete outlet.

Protect the power cord from being walked

on or pinched particularly at plugs, con-

venience receptacles and at points of exit

from the device.

Only use the attachments or accessories

specified by the manufacturer.

Ensure that there is adequate ventilation.

Leave 20cm (8") of free space at the top

and sides and 10cm (4") at the rear. The

rear edge of the shelf or board above

the device should be set 10cm (4") away

from the rear panel or wall. Good airflow

is necessary to help ensure proper

operation. Not only should you provide

enough free space around the device,

but also ensure that air can flow freely

and escape from the device's surround-

ings. Failure to do so may cause thermal

shutdown of the device, and reduced life

expectancy.

Unplug this device during lightning

storms or when unused for long periods

of time.

10. Refer all servicing to qualified service

personnel. Unplug the device from

the wall outlet and refer servicing to

qualified service personnel under the

following conditions:

a. Power supply cord or plug is damaged.

b. Objects have fallen into the device.

c. Exposure to water or other liquids.

d. If the device does not operate

normally by following the operat-

ing instructions. Adjust only those

controls that are covered by the

operating instructions as an im-

proper adjustment of other controls

may result in damage and will often

require extensive work by a qualified

technician to restore the device to its

normal operation.

e. If the device has been dropped or

damaged in any way.

f. When the device exhibits a distinct

change in performance. This indicates

a need for a service.

11. Object and Liquid Entry; never push ob-

jects of any kind into the device through

openings as they may touch dangerous

voltage points or short-out parts that

could result in a fire or electric shock.

Precautions

AC Fuse

The AC fuse inside the device is not

user-serviceable. If you cannot turn on

the device, contact the dealer from whom

you purchased this device.

Care

Occasionally you should dust the device

all over with a soft cloth. For stubborn

stains, use a soft cloth dampened with

a weak solution of mild detergent and

water. Dry the device immediately

afterwards with a clean cloth. Never use

abrasive cloths, thinners, alcohol, or other

chemical solvents, since they may damage

the finish or remove the panel lettering.

POWER WARNING: Before plugging

in this device for the first time, read

the following section carefully.

AC outlet voltages vary from country

to country. Make sure that the voltage

in your area meets the voltage require-

ments printed on the device's rear panel.

(e.g. AC 90V – 240V 50/60HZ) The pow-

er cord is used to disconnect this device

from the AC power source. Make sure

that the plug is readily operable (easily

accessible) at all times. If you do not

intend to use the device for an extended

period, remove the power cord from the

AC outlet.

Ground

The device is defined as Class1 in EN60065

(low voltage directive) and MUST BE

GROUNDED. Connect only to an outlet

with protective ground, and only use the

power cord supplied.

Finland: "Laite on Liitettävä suojamaadoi-

tuskoskettimilly varustettun pistorasiaan."

Norway: "Apparatet må tilkoples jordet

stikkontakt."

Sweden: "Apparaten skall anslutas till

jordat uttag."

Never Touch Device with Wet Hands

Never handle this device or its power

cord while your hands are wet or damp.

If water or any other liquid gets inside

this device, have it checked by your

Autonomic dealer.

Handling Notes

a. If you need to transport this device,

use the original packaging to pack it

how it was when you bought it.