Dynacore DW-500BR Manuale d'uso - Pagina 5
Sfoglia online o scarica il pdf Manuale d'uso per Trasmettitore Dynacore DW-500BR. Dynacore DW-500BR 9. Sdi/hdmi 150m wireless transmission system
Stampa la paginaWireless Transmission System
Typical connection instruction
Connect camera SDI or HDMI output to transmitter SDI or
HDMI input port, and the transmitter can be fixed in
hot-shoe port of the camera. Connect HDMI or SDI output
port of the receiver to SDI or HDMI input port of the HD
monitor. Make sure all antennas and batteries are equipped
normally.After finishing all steps above, system is workable,
follow below steps.
a) Ensure the video source output of the camera is OK, and
the HD monitor is power on and switched to connected
video input port.
b) Ensure all input, output SDI or HDMI cables are connected.
c) Ensure DW-500BT 2 antennas are installed, and it is better
to keep DW-500BT 2 antennas with orthogonal angle each
other for best DW-500BR performance. Looks like below
figure.
PAGE 8
Transmitter
Wireless Transmission System
d) Ensure both the transmitter and receiver are installed
with battery or DC input port which is connected to
outside power source. Then turn power switch of
transmitter and receiver to 'ON' respectively, then
'Power' indicator will light.
e) Ensure the frequency knobs of transmitter and receiver
are set with the same number, and this will make sure
the transmitter and receiver work with same frequency.
f)
If the camera is on and video input is OK,DW-500BT side
'Video' indicator will light.
g) Before DW-500BR finished wireless link with DW-500BT,
4 'RSSI' indicators and 'Video' indicators will be off;
when wireless link is OK, 'RSSI' indicators will light first,
and 'RSSI' will indicate the received DW-500BR signal
strength. If the receiver detects wireless video normal
internally from air interface, 'Video' indicator will light.
Before that, if SDI or HDMI video out port of the
receiver has HD monitor connected, it will display an
OSD of 'Link connecting......' like below picture.
Link connecting ...
h) The system will spend 20-30 seconds on constructing
communication link, and real link period will depend on
the current wireless channel condition. When wireless link
is set up, 'RSSI' light will light and indicate current
received wireless signal strength, as well 'Video'
indicators will light, and then connected HD monitor will
display the video and audio accordingly.
PAGE 9