HiBoost F12G-3S-BTW Manuale d'uso - Pagina 5

Sfoglia online o scarica il pdf Manuale d'uso per Estensore HiBoost F12G-3S-BTW. HiBoost F12G-3S-BTW 13.

2.2 Plan the layout of your system

Before you get started you will need to plan the layout of your system. This involves

checking signal strength for signals coming from the cellular tower, as well as

antenna, booster and cable placement.

2.3 Check for Signal Strength

Select a location on the roof of the vehicle to install the signal antenna, by

monitoring your cellular phone's signal strength (signal bars) to find the strongest

signal from your carrier's cellular tower.

Mark that area as the installation location for the Donor (outdoor)

IMPORTANT: To prevent the systemfrom oscillation (feedback) you want to ensure

that there is enough separation between the distribution and signal antenna or that

they are shielded from each other to ensure the distribution antenna does not send

a signal back into the signal antenna. If you cannot achieve these separations, either

choose an alternate location for the donor (outdoor) antenna or determine if there

are natural barriers in the building construction itself that will attenuate signals

between the two antennas so that oscillation can be prevented.

2.4 Run coaxial cable

Loosely run the coaxial cable from your outdoor antenna to your booster. (Afteryou

have tested the system you can permanently secure thecoaxial cable).

As you route and pull cabling, follow these general guidelines:

Bend cables and route them smoothly, and protect the outer skinagainst any

damage.

Keep horizontal cables straight and fasten them with a tie every two to three

feet.

Bind and fasten vertical cables every two to three feet.

Waterproof all outdoor connections with silicone caulking

Be careful when plugging the connector in so as not to damagethe center pins

on the connectors.

2.5 Install the Donor (Outdoor) antenna

Connect the supplied coaxial cable to the antenna. We recommend applying silicone

caulking to fully waterproof the connection.

Attach the cable in such a way that a drip loop is formed.

Once mounted, connect one end of the coaxial cable to the donor (outdoor) antenna

and the other end to the cellular booster where it is marked "Outdoor"

5 / 13