HiBoost Hi10-17 Manuale d'uso - Pagina 10
Sfoglia online o scarica il pdf Manuale d'uso per Estensore HiBoost Hi10-17. HiBoost Hi10-17 14.
Stampa la pagina"沿
DOST
Single and Dual Band
3. Connect the outdoor antenna cable to the booster connector marked as "outdoor". Tighten the connection by hand
。「with a wrench.
4. Connect the indoor antenna cables to the booster connector marked as勹ndoor". Tighten the connection by hand or
with a wrench.
5. Connect the AC power cord to the signal booster, then connect the plug to the electrical outlet to power on the
booster.
Note·the required booster mounting d叹ance above the floor 1s 1-1,8 m
If i t' s necessary to install multiple indoor antennas solution, please contact us, We will provide you with a professional
1nstallat1on plan
Step 4. Booster Commissioning
The booster has an intelligent startup system, booster commissioning is an automatic process able to guarantee an
optimal system performance.
As soon as you finish the booster system installation, plug it into a power supply to start the booster. It will start working
and checking the receiving signal strength and the isolation to ensure the best system performance. Automatic
ad」ustment will take about 3-5 seconds
After the booster starts working, check the coverage. If the signal has improved throughout your home/office, the
booster commissioning is completed
In case the coverage is not enough, please check the following issues
1. The rated output power is reached, but the coverage is not enough o「the signal in some a「 eas has not improved
• Check whether the indoor antenna 1s installed correctly or not, try to change the antenna pos1t1on to improve coverage
• Check 1 / 1t is necessary to adJust the direction of the indoor antenna.
• Check whether it is necessary to add more indoor antennas since the obstructions (thick walls, reinforced fence, natural
barriers like hills, mountains, etc.) block the signal
2. The rated output power is not reached
• Change the position or direction of the outdoor antenna to get a stronger receiving signal and higher output power
(Not necessarily to reach the rated value as long as the coverage is enough)
• Check the LCD display. If the current gain is less than the rated value and "ISO" is flashing, it means the gain is reduced
＿
by ISO function for not having enough isolation
More about "ISO" legend indication
＿
ISO status indicates if the booster has enough isolation between the outdoor and indoor antennas in order to avoid loop
back o「so-called self-oscillation. HiBoost is equipped with a smart AGC function to avoid interference with mobile
networks "ISO" flashing on the LCD display means that ISO function 1s working great and self-osc1llat1on has been
el1m1nated
Remain still
ISO
Flashing but actual gain is not more
status
than 30dB and less than rated gain
Flashing but actual gain IS more
than 30dB
More about "ALC" legend indication
ALC indicates the strength of receiving power of the booster. Flashing ALC means that the booster has strong rece,v,ng
power
Triple and Quintuple Band
＿ －
No loop back or no self-oscillation.
Slight loop back or self-oscillation.
Deep loop back or self-oscillat,on
H1103S/Hi105S
No action is needed
No action ,s needed
Please check the Troubleshooting
section to get solutions