GAI-Tronics ILC-1117 Manuale d'installazione e d'uso - Pagina 6
Sfoglia online o scarica il pdf Manuale d'installazione e d'uso per Telefono GAI-Tronics ILC-1117. GAI-Tronics ILC-1117 20. Titan illuminated crossing telephone
Stampa la pagina
4.
Installation
4.1. General
All possible measures must be taken to ensure water, fluid or dust
does not contaminate the internal components of the telephone whilst
unpacking, preparing and installing the telephone in inclement weather
conditions or by negligence.
Failure to do so may invalidate your warranty.
These telephones are supplied without connection leads – cabling to the
telephone network must be supplied and installed by the installer. Because of
this, extra precautions must be observed: installation must be carried out by
trained personnel. Contact GAI-Tronics if installation service is required.
1.
To prepare for installation, open the door, then undo the four retaining
screws to remove the faceplate from the rear enclosure. A 3mm Allen
key is required. Take care not to damage the exposed circuit board
when setting the faceplate aside during installation.
Caution – take care to support the spring-loaded door whilst open
to prevent it slamming shut and trapping fingers.
2.
All connections and option settings are on the rear of the faceplate
towards the lower edge.
3.
The Titan telephone is intended for vertical installation to a wall or pole.
Select the required mounting method (section 4) and mount the rear
enclosure first where applicable.
4.
Route the required cables through glands as appropriate, and make
connections and option settings following section 5.
Ensure that both cable entries are sealed with either a gland or a black
blanking plug as described.
5.
Re-fit the faceplate ensuring a weatherproof seal is maintained.
6.
Test the operation of the telephone (section 3). Installation is now
complete.
4.2. If glands are required
Before mounting the telephone, check the cable routing and requirements. If
glands are required, fit them to the case as follows:
1. Remove the RED blanking plug leaving the other (usually BLACK) in
place.
6
IMPORTANT
ILC-1117 Titan Illuminated Crossing Telephone