GAI-Tronics PHP400 Manuale d'installazione e d'uso del progetto - Pagina 6
Sfoglia online o scarica il pdf Manuale d'installazione e d'uso del progetto per Telefono GAI-Tronics PHP400. GAI-Tronics PHP400 20. Analogue version (1090/1099 series) with ampetronic hls-dm2 induction loop amplifier 230v ac power supply
Anche per GAI-Tronics PHP400: Manuale d'installazione e d'uso (20 pagine), Manuale d'installazione e d'uso (20 pagine)
Stampa la pagina
Refer to the VoIP configuration guide 502-20-0119-001 for full details on all settings.
The configuration guide is available from
To configure the unit it must first be powered, but note that the VoIP module itself can be
powered via PoE if required. External power is only necessary because of the induction loop
system.
As a quick guide the 2 most common methods of configuration are:
1. Make a direct network connection to the unit (for example using a crossover cable to
a laptop), then access the unit's web pages by browsing to 192.168.1.2, or
2. Make a serial connection to the unit, enter the login and password, then use CLI
commands such as:
IP SET DHCP ON, or
IP SET ADDRESS ...
IP SET MASK ...
etc.
The current IP settings can be displayed by entering IP SHOW ALL.
Site requirements
3.3.
Having configured the unit for the intended network, ensure that the following are available
for installation:
1. Power supply: 48V dc @ 2A.
2. Ethernet connection – 10/100BaseT on CAT5/CAT5e UTP cable, the cable run is
normally limited to 95m.
3. This is normally a two-person installation, due to the size/weight of the unit and due
to the need to connect cables between the 2 sections.
Installation and dimensions
4.
General
4.1.
THIS PRODUCT CAN CONTAIN HAZARDOUS VOLTAGES. IT IS ESSENTIAL
THAT THE WATERPROOF SEAL IS PROPERLY MADE DURING INSTALLATION,
TO ENSURE THAT WATER CANNOT GET INTO THE ENCLOSURE. THE
INGRESS OF WATER CAN CAUSE ACCESSIBLE PARTS OF THE TELEPHONE
TO BECOME LIVE, AND THEREFORE MUST BE PREVENTED AT ALL COSTS.
All possible measures must be taken to ensure water, fluid or dust does not
contaminate the internal components of the unit whilst unpacking, preparing and
installing it in inclement weather conditions or by negligence.
Do not drill any additional holes in the casing. Make sure any unused cable
entry or mounting holes are properly sealed against water or dust ingress.
Failure to do so may result in an unsafe condition and will invalidate your
warranty.
www.gai-tronics.org/support/voip-support/
IMPORTANT
400mm VoIP Help Point, 48V VoIP.
6