GAI-Tronics Titan CB Manuale d'installazione e d'uso - Pagina 10
Sfoglia online o scarica il pdf Manuale d'installazione e d'uso per Telefono GAI-Tronics Titan CB. GAI-Tronics Titan CB 20. Weather resistant telephones
Stampa la pagina
5.2.2
Kit No 100-02-0208-001
This accessory is for mounting GAI-Tronics telephones on to the side of
round poles of 100mm to 200mm diameter, or on to square or
rectangular section uprights of 100mm to 150mm across the mounting
surface.
NOTE:
Banding straps (large scale worm-drive clamps) are not included in this
kit and must be obtained separately. For details of where banding can
be obtained, refer to GAI-Tronics.
1. After punching through the flanged bushes in the rear enclosure (as
described in WALL MOUNTING), attach the pole mounting clamp
assemblies to the rear enclosure using the M6 x 25 screws
provided. Tighten to a torque of 4.5Nm max.
Note: only use the outer four holes, and ensure that the screws seat
properly in the plastic bushes to avoid water ingress.
2. Ensuring that the glands are at the bottom, pass a proprietary
banding strap round each of the pole mounting clamps and the
support pole. Tighten securely.
3. Continue the installation by making the appropriate connections
(section 6) and re-fitting the face plate.
4. Re-tighten the straps firmly and trim off any excess band material.
For security the driving head of the band may also be sawn off.
5.2.3
Titan telephones supplied for flush mounting have a slightly different
faceplate to those supplied with a rear enclosure – in particular the fixing
holes are in different positions and there are no corner cut-outs (for door
hinges). These models are usually described as "Titan fp" and the
supplied mounting kit contains round-headed screws and no glands.
10
Pole mounting
Flush mounting
Titan CB, Commander CB