Greatneck 80161 Manuale d'uso - Pagina 12
Sfoglia online o scarica il pdf Manuale d'uso per Sega Greatneck 80161. Greatneck 80161 18. High speed circular saw
Stampa la pagina
CHANGING THE BLADE – cont'd
6.
Place the large outer flat washer onto
the motor shaft.
NOTE: Make sure the flat sections of
the large outer flange washer fit over
the matching flat sections on the motor
shaft.
7.
Insert the blade screw through the lock
washer, flat washer and the large outer
flange washer and thread it clockwise
into the end of the motor shaft.
8.
Lock the motor shaft using the shaft
locking button and firmly tighten the
blade screw using the hex key.
NOTE: Make sure the screw is NOT
cross-threaded and that the blade
does not wobble when turned by hand.
SETTING THE CUTTING DEPTH
The cutting depth of the blade should be
set to suit the thickness of the material
being cut. The cutting depth should be
1
approximately
/
" (3 mm) greater than the
8
thickness of the material being cut.
1.
Loosen the depth adjustment lever (1)
by pulling it outward (Fig. 5).
2.
Pull the sole plate (2) downward until
the correct amount of the blade is
protruding below the sole plate.
3.
Push down firmly on the depth
adjustment lever to lock the sole plate
in position.
ASSEMBLY AND OPERATION
Fig. 5
BEVEL CUTTING
The sole plate can be tilted to provide bevel
cuts from 0–45°.
1.
Loosen the bevel gauge adjustment
knob (1) by turning it counter-
clockwise (Fig. 6).
2.
Rotate the sole plate (2) to the desired
angle as shown on the gauge (3), and
the alignment mark.
3.
Tighten the bevel gauge adjustment
knob to lock the sole plate in position.
4.
Make a test cut on a scrap piece of the
workpiece to verify that the cutting
angle is set properly.
5.
Adjust cutting angle as necessary.
12
Fig. 6