Greatneck 80161 Manuale d'uso - Pagina 7

Sfoglia online o scarica il pdf Manuale d'uso per Sega Greatneck 80161. Greatneck 80161 18. High speed circular saw

Stampa la pagina

Make sure your extension cord is the

proper size. When using an extension

cord, be sure to use one heavy enough to

carry the current the tool will draw.

An undersized cord will cause a drop in line

voltage resulting in loss of power and

overheating. The table below shows the

correct size to use according to cord length

and nameplate ampere rating. If in doubt,

use the next heavier gauge. The smaller

the gauge number the heavier the cord.

Be sure your extension cord is properly

wired and in good condition. Always

replace a damaged extension cord or have

it repaired by a qualified electrician before

using it. Protect your extension cord from

sharp objects, excessive heat and damp or

wet areas.

Use a separate electrical circuit for your

power tools. This circuit must not be less

than 14 gauge wire and should be

protected with either a 15A time delay fuse

or circuit breaker. Before connecting the

power tool to the power source, make sure

the switch is in the OFF position and the

power source is the same as indicated on

the nameplate. Running at lower voltage

will damage the motor.

WARNING:

damaged or worn extension cords

immediately.

Select the appropriate extension cord

gauge and length using the chart at right.

EXTENSION CORD GUIDELINES

Repair or replace

MINIMUM GAUGE (AWG) EXTENSION

CORDS (120 V use only)

Ampere rating

Not

than

Total length in feet

25'

50'

100'

150'

Not

Applicable