HID Vertx CS V100 Manuale di installazione rapida - Pagina 3
Sfoglia online o scarica il pdf Manuale di installazione rapida per Controllore HID Vertx CS V100. HID Vertx CS V100 9.
Stampa la pagina
- 1. QUICK START, VERTX (CS) V100 Door/Reader Interface Panel
- 2. Table of Contents
- 3. Introduction
- 4. Parts List (Included)
- 5. Product Specifications
- 6. Cable Specifications
- 7. Overview
- 8. Step 1 Preparations
- 9. What You Need before Getting Started
- 10. Step 2 Hardware Installation
- 11. Mounting Instructions
- 12. Wiring Vertx
- 13. Contact Information
VertX V100 (CS) Quick Installation Guide
Introduction
VertX™ CS is the first family of access controllers designed specifically for alarm dealers for direct
connection to central stations. Because it was designed with central station in mind, VertX CS works with
software from leading central station automation providers, including Bold Technologies, DICE and
GE MAS.
The V100 is designed to be controlled by a VertX V1000 Access Controller that will also manage
communications with the central station automated software. The V100 Door/Reader Interface panel
controls two sets of door devices or one door with Card In/Card Out (a reader on both sides of the same
door.)
Parts List (included)
Parts List (included)
VertX™ V100 Door/Reader Interface
Note: The V100 panel has a plastic base
and is covered with a Plastic or Mylar cover.
Mounting screws
2.2K EOL resistors
Quick Installation Guide
Installation Wiring Diagram Example
Note: A VertX V1000 Access Controller is required.
Product Specifications
Description
Power Supply
Maximum current at 12VDC per V100
Average operating current at 12VDC
Operating temperature range
Humidity
Cable Specifications
Cable Type
RS-485 *
4000 feet (1220 m) to V1000
Input Circuits *
500 feet (150 m)
Output Circuits *
500 feet (150 m)
500 feet (150 m) to reader
Wiegand
Power Supply
----
+12 VDC IN
* Minimum wire gauge depends on cable length and current requirements.
August 2005
Quantity
1
4
4
1
1
Specification
12-16VDC
1 Amp
450mA (with two R40 iCLASS Readers)
32°-122°F (0°-50°C)
5% to 95% non-condensing
Length
Belden 3105A, 22AWG twisted pair, shielded 100Ω cable, or equivalent.
2-conductor, shielded, using ALPHA 1292C (22AWG) or Alpha 2421C
(18AWG), or equivalent.
2-conductor, using ALPHA 1172C (22AWG) or Alpha 1897C (18AWG), or
equivalent.
ALPHA 1299C, 22AWG, 9-conductor, stranded, overall shield.
Fewer conductors needed if all control lines are not used.
Refer to your Power Supply Installation Guide.
2005 © HID Corporation. All rights reserved.
Specification
Page 3 of 9