Gainsborough Z5R Series Istruzioni per l'installazione

Sfoglia online o scarica il pdf Istruzioni per l'installazione per Per serrature Gainsborough Z5R Series. Gainsborough Z5R Series 2.

Installation Instructions for Z5R & S5R Series Dummy Lever

Step 1.

• Fold Template where indicated.

• Position template on door edge at desired height.

• Firmly hold template & mark 5 hole centres (4 off 9mm

& 1 off 25mm) at required backset.

Note: 25mm hole 10mm deep only.

• Drill Pilot holes - suggest 3mm, then enlarge (4 off) 9mm

holes from both sides of door.

• Drill (1 off) 25mm hole 10mm deep on side of door dummy

leverset will be fitted.

Step 2.

Install lever assemblies to door: Z5R, S5R, Z5S & S5S Series Dummy Lever

• Remove rosette cover (1a or 1b) from lever assembly.

• Place dummy lever assembly (2) with latch alignment posts (3) against door face.

• Place dummy plate (4) into position, on back of door.

• Fasten lever assembly & dummy plate together with screws (5) & tube nuts (6)

provided: Use long screws for thick doors and short screws for thin doors.

• Install screws (5) from dummy plate side into the vertical tube nut holes (8) of the

dummy leverset under-rose. Then tighten both screw heads.

Z5R & S5R

• Reapply rosette cover (1a) to under-rose by pushing the cover over the rubber ring

until flush with door.

Z5S & S5S

• Reapply rosette cover (1b) to under-rose by pushing the cover

over the rubber ring until flush with door. The *grub-screw, which is

already located in the rosette cover, should be on the lower face.

• Check the rosette cover is square with the door edge. Fasten in place

with *grub-screw using allen key (9) provided.

*Note: Grub-screw is already located in the rosette cover.

Gainsborough Hardware Industries Limited,

Melbourne, Australia. A.B.N. 25 004 792 269

www.gainsboroughhardware.com.au

55A1DOC04BT1

AT 000

JUN '12

and Z5S & S5S Series Dummy Lever

FOLD HERE

9mm hole

25mm hole

x 10mm deep

Important Note:

Don't drill this hole

through the door.

Installation template

for dummy applications