GainSpan GS1011M Series Manuale d'uso - Pagina 9

Sfoglia online o scarica il pdf Manuale d'uso per Scheda madre GainSpan GS1011M Series. GainSpan GS1011M Series 12. Serial to wi-fi evaluation kit

Serial to Wi-Fi Start Up Guide

EGULATORY

OTES

Federal Communication Commission Interference Statement

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant

to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful

interference in a residential installation. This equipment generates uses and can radiate radio frequency

energy and, if not installed and used in accordance with the instructions, may cause harmful interference

to radio communications. However, there is no guarantee that interference will not occur in a particular

installation. If this equipment does cause harmful interference to radio or television reception, which can

be determined by turning the equipment off and on, the user is encouraged to try to correct the interfe-

rence by one of the following measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

- Consult the dealer or an experienced radio/TV technician for help.

FCC Caution: To assure continued compliance, (example - use only shielded interface cables when con-

necting to computer or peripheral devices). Any changes or modifications not expressly approved by the

party responsible for compliance could void the user's authority to operate this equipment.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1) This device may not cause harmful interference, and (2) this device must accept any interference re-

ceived, including interference that may cause undesired operation.

IMPORTANT NOTE:

FCC & IC Radiation Exposure Statement:

This equipment complies with FCC & IC radiation exposure limits set forth for an uncontrolled environ-

ment. This equipment should be installed and operated with minimum distance 20cm between the radiator

& your body. This transmitter must not be co-located or operating in conjunction with any other antenna

or transmitter. This device is intended only for OEM integrators under the following conditions:

1) The antenna must be installed such that 20 cm is maintained between the antenna and users, and

2) The transmitter module may not be co-located with any other transmitter or antenna.

As long as 2 conditions above are met, further transmitter test will not be required. However, the

OEM integrator is still responsible for testing their end-product for any additional compliance require-

ments required with this module installed (for example, digital device emissions, PC peripheral require-

ments, etc.).

IMPORTANT NOTE: In the event that these conditions cannot be met (for example certain laptop confi-

gurations or co-location with another transmitter), then the FCC & IC authorizations are no longer consi-

dered valid and the FCC & IC IDs cannot be used on the final product. In these circumstances, the OEM

RELIMINARY

AGE

ONFIDENTIAL