Hides HV-110 Manuale - Pagina 4

Sfoglia online o scarica il pdf Manuale per Ricevitore Hides HV-110. Hides HV-110 4.

Factory Reset - Last resort if receiver won't work or misbehaving.

defaults are loaded.

9 -

Main Menu -Tools

System Information

Version:

this is the firmware version currently loaded in the receiver.

Normally, only the last 2-3 numbers are incremented.

found in the release notes file.

0.0.1.72.157

10 -

Rear Panel DC Connectors

Early model HV-110 use a coaxial DC power connector with a center pin of 2.5mm

and 5.5mm barrel. The HV-110 is a 5 volt-only model and should never be

connected to 12 volts. The larger center pin helped to avoid connecting a 12

volt "wall wort" which are (with few exceptions) 2.1mm center pins.

the later HV-110 were manufactured with smaller 2.1mm center pins (12vdc) power

connectors.

Why they made the change is anyone's guess so be careful when

connecting power to the later HV-110 receivers.

use 2.1mm center pins for nominal 12 volt power.

Performance

The signal LED will be bright red with no signal present. Upon receiving a

valid signal, the LED will turn from red to green and the PC/TV will display

the video in about 5-6 seconds.

seconds longer.

signals.

HDTV sets generally provide a better "picture" than PC monitors. TVs

with built in sound/speakers also avoid the hassle of the PC sound card

configuration.

(www.kh6htv.com) for comparison of HIDes receivers.

be made when selecting the HV-120 and 122 receivers since several modes are

available with filters and frequency coverage that will effect performance for

the 70cm band.

Mel, K0PFX

Perform set up steps.

Audio is the less robust and prone to dropouts on marginal

Refer to Jim Andrew KH6HTV's application note AN-57

The latest version as of August 2020 is

Audio is processed last and may take several

The date associated is

The HV-120 and HV-122 both

Careful consideration must

All

However,