Celestron TRAVEL SCOPE 60 Manuale di istruzioni - Pagina 2
Sfoglia online o scarica il pdf Manuale di istruzioni per Telescope Celestron TRAVEL SCOPE 60. Celestron TRAVEL SCOPE 60 6.
Anche per Celestron TRAVEL SCOPE 60: Manuale di configurazione rapida (4 pagine), Manuale di configurazione rapida (8 pagine)
Stampa la pagina
WHAT'S IN THE BOX
We recommend saving your telescope box so it can be used to store the telescope when it is not in use. Unpack the box carefully as
some parts are small. Use the parts list below to verify that all parts and accessories are present.
PARTS LIST
Telescope Tube
Objective Lens
(under lens shade)
Central Column
Locking Knob
Tripod
SOLAR WARNING
Never look directly at the Sun with the naked eye or with a telescope unless you have the proper solar filter. Permanent and irreversible eye damage may result.
Never use your telescope to project an image of the Sun onto any surface. Internal heat build-up can damage the telescope and any accessories attached to it.
Never use an eyepiece solar filter or a Herschel wedge. Internal heat build-up inside the telescope can cause these devices to crack or break, allowing unfiltered
sunlight to pass through to the eye.
Do not leave the telescope unsupervised, especially when children or adults unfamiliar with the correct operating procedures of your telescope are present.
Designed and intended for those 14 years of age and older.
ASSEMBLY
Set up your Travel Scope indoors the first time and familiarize yourself with the correct assembly procedure before attempting it outdoors.
SETTING UP THE TRIPOD
1. The tripod comes preassembled. Stand the tripod upright and pull the tripod legs outward until each leg is
fully extended.
2. You can raise the tripod legs to the height you desire. At the lowest level, the height is about 16" (41cm) and
extends to about 49" (125cm).
3. To raise the height of the tripod, unlock the tripod leg lock clamps at the bottom of each tripod leg by opening the
clamp for each section and pulling outward. Once a clamp is unlocked, pull the tripod leg out as far as it will go and
then close the leg lock to secure it. Continue doing this for each tripod leg and each section to raise the height to
the level you desire.
4. If you want to raise the tripod height up further, use the central column locking knob. Turn the locking knob
counterclockwise until loose. Then, pull up on the head of the tripod. Continue pulling to the height you desire and
then tighten the locking knob.
2
| TRAVELSCOPE 60
OTHER INCLUDED ACCESSORIES:
Finderscope
Erect Image
Diagonal
Focus Knob
Tripod Head
Platform
Pan Handle
1.25" Moon Filter
20mm Eyepiece
10mm Eyepiece
3x Barlow Lens
Travel Backpack