Kintech Engineering BGAN Installazione e orientamento dell'antenna - Pagina 2
Sfoglia online o scarica il pdf Installazione e orientamento dell'antenna per Data Loggers Kintech Engineering BGAN. Kintech Engineering BGAN 8.
Anche per Kintech Engineering BGAN: Manuale d'uso (10 pagine)
Stampa la paginaBGAN SATELLITE | INSTALLATION & ANTENNA ORIENTATION
HOW TO PREPARE ORBIT, MOXA & BGAN MODEM
1. Verify that all cables are plugged in correctly and check for continuity (according to the wiring diagram shown below).
2. Make sure the data logger has the correct .sit file configured with BGAN communication in Atlas (see chapter 4).
3. Verify that BGAN SIM card is activated correctly including data plan.
HOW TO INSTALL AND PRE-ORIENTATE THE BGAN ANTENNA
The BGAN system operates with a directional antenna which means that the orientation of the antenna is crucial for its opera-
tion and good coverage.
Before installing the antenna support boom to the mast make sure the antenna will be located and orientated in such a way
that it has a clear line of sight between the antenna and the satellite (unobstructed).
Follow these steps to verify in what direction to point the antenna. These steps should be performed outside:
Do not stand in front of the antenna. This device emits high-energy radiofrequency waves. Do not place the head or
other body part in front of the satellite antenna when the system is operational. Keep a distance of at least 1 m from the front
of the satellite antenna.
1. Connect the RF antenna and screw the antenna onto the support boom (final antenna orientation will be adjusted later).
2. Connect the cross-wire ethernet cable from the BGAN modem to your laptop.
3. Power on the BGAN modem.
4. Wait until the Power and the GPS LEDs are on (fixed).
5. Disable the Wifi connection on your laptop.
6. Open "Control Panel" > "Network and Internet" > "Network and Sharing Center" > "Ethernet".
7. In the "Ethernet Status" tab, click on "Settings".
8. In the "Ethernet Settings" tab, click on "Internet Protocol version 4 (TCP/IPv4)".
9. In the "Internet Protocol version 4 (TCP/IP)" tab, click on "Obtain an IP address automatically".
10. Finally, click on "OK" until you exit the menu.
For more information please contact [email protected]
or visit our website www.kintech-engineering.com