AutoMotionShade EL-204P-2 Manuale di riferimento rapido - Pagina 2

Sfoglia online o scarica il pdf Manuale di riferimento rapido per Telecomando AutoMotionShade EL-204P-2. AutoMotionShade EL-204P-2 3.

All above transmitters will work with Motor 4240N in conjunction with Module 216P.

Please note that 1

and 2

works with 2

generation RF Transmitters.

Special Feature: Module 216P gives you the option to control a motor both remotely with an RF transmitter and

by means of a wall switch.

to 12VDC Power

1. Connect the Module output wire (A) to the short Shade power wire (B); if wired switch control is desired,

connect the wire coming from the wall switch that controls the shade to Module wire (C). This wire can be

left unused if no hardwired wall switch control is needed.

2. Ensure the Module is connected to a 12V DC power supply (white wire to ground, black wire to 12V power).

A green light on the Module must be lit. If you do not see a solid green light, the Module is either not

properly powered or the Module may be faulty.

3. On the RF Transmitter, select the channel you want to program by pressing the button of that channel.

4. On the Receiver Module, press the small micro push button (D) with a ball pen point and hold until the color

of the light changes from green to red; now release it and immediately without delay press and hold the

micro push button inside the small hole on the back of the transmitter (using e.g. a paper clip) for few

seconds (on transmitter EL-213P "SET" appears on the display), then release it and immediately press the

stop button on the front of the transmitter.

407: R-1: 02/20

generation RF Transmitters are not interchangeable; the external Module 216P only

For internal wiring and limit adjustments of Cellular Shade refer to QRG #21;

(C)

- to wired switch (optional)

(D)

External RF Receiver Module EL-216P

(As an option, Module 216P can also be

fitted inside the headrail)

Effective Date: Feb 2020

(B)

Micro Push Button

(A)