Celina MASTER SERIES Manuale del prodotto - Pagina 12
Sfoglia online o scarica il pdf Manuale del prodotto per Tenda Celina MASTER SERIES. Celina MASTER SERIES 15. 20’ x 30’ high peak frame tent sectional
Striking Instructions
1. Loosen all ratchet assemblies.
2. Remove the stakes from master series base plates.
3. Remove the interior side tee ratchet assemblies.
4. Remove the side legs leaving the 4 corner legs.
5. Unfasten all anchoring devices from the perimeter tubing (with the exception of 2 at each corner).
6. Remove 2 corner legs from one side and carefully set the tent frame on the ground.
7. Remove the peak extension pole(s).
8. Remove the 2 remaining corner legs and carefully set the tent frame on the ground.
9. Unfasten the rest of the straps, completely disconnecting the tent top from the frame and stakes.
10. Roll out a drop cloth next to the frame.
11. Carefully remove the tent top from the frame, lifting up on the fabric or "flapping" it to create a cushion of air.
12. Unlace the tent top:
a. Separate the valance hook and loop that connects the tents together. Unclip the rain flap until the
lace line tie-off is accessed.
b. Untie knot and unlace the tent top section while disconnecting the rain flap.
13. Fold and roll the tent top as tight as possible. Remember not to stand or walk on the tent top fabric.
14. Bagging (always use a drop cloth to protect the tent top from dirt and abrasions while bagging):
a.For Wrap-Around Tent Bag:
i.Lay the bag next to the tent top with the side-release buckles facing down. Roll the tent top
onto the center of the bag.
ii.Connect the two short male and female side-release buckles; pull tight.
iii.Connect the remaining side-release buckle and pull tight.
b. For Round-Bottom Bag:
i. Place the folded tent top into the upright vertical position.
ii. Pull the round bottom tent bag over the upright tent top.
iii. Turn the tent top and bag over, pull the draw string tight and tie off.
15. Fold and roll up the drop cloth.
16. Remove the crown adapter from the crown fitting. Disassemble all of the corner, side tee, and crown
fittings by removing the pins and sliding the tubing off of the fittings. Work from the perimeter of the frame
inward.
17. Remove remaining stakes.
20' x 30' Master Series High Peak Frame Tent
INSTALLATION INSTRUCTIONS
www.GetTent.com / www.CelinaTent.com
© 2013 Celina Tent Inc.
PG.12