Hifionics Titan TXi10080 Manuale d'uso - Pagina 9
Sfoglia online o scarica il pdf Manuale d'uso per Amplificatore Hifionics Titan TXi10080. Hifionics Titan TXi10080 15. Titan series high performance amplifiers
Stampa la pagina- 1. Table of Contents
- 2. General Installation Procedure
- 3. Amplifier Feature Descriptions
- 4. Txi4008 / Txi6008 2-CHANNEL AMPLIFIER APPLICATIONS
- 5. Txi4408 / Txi6408 4 -CHANNEL AMPLIFIER APPLICATIONS
- 6. Txi7508 A/B CLASS 1 CHANNEL AMPLIFIER APPLICATIONS
- 7. Txi1008D / Txi1508D D CLASS 1 CHANNEL AMPLIFIER APPLICATIONS
- 8. Features and Specifications
- 9. Setting up Systems after Installation for Best Performance
- 10. Troubleshooting and Diagnostics
- 11. Product Warranty
TXi7508 A/B CLASS 1 CHANNEL AMPLIFIER APPLICATIONS
Basic application
These sub bass amplifiers can be used in any of the bi-amplification systems described in
this manual, replacing the 2 channel amplifiers as per the illustrations.
Interconnect cable checklist:
Connect the inputs to a suitable source, e.g. a head unit with good quality RCA cables.
Connect the LINE OUT to the inputs of the system highs amplifier.
Use at least #12 gauge speaker wiring. The amps have dual speaker terminals,
simplifying the hookup of multiple speakers
DESIGNATED
MONO OUTPUT
FROM HEAD UNIT
MINIMUM 1-Ohm LOAD
SUBS CAN BE 2-Ohms EACH
POWER INPUT
GND
REM +12V
FULL RANGE
STEREO LINE INPUT
Note: You can use the Radio/CD designated mono line output or a full range stereo line output.
For full range stereo line output, you will need an optional "Y-Adaptor" as shown.
Crossover frequency control checklist:
LOW PASS: 40Hz to 150Hz
SUBSONIC:15 Hz to 55 Hz
BASS EQ: 0 to +12dB
Level control checklist:
Refer to the section "Setting up systems after installation for best performance"
Minimum final loudspeaker impedance: 1-Ohm.
SPEAKER OUTPUT
FUSE
+
+
Y-ADAPTOR
NOT USED
-
-
MONO
SUBWOOFER
TO BATTERY + 12 Volts
VIA FUSE
REMOTE TURN-ON
CHASSIS GROUND
7