8STREME 7310 Manuale - Pagina 14
Sfoglia online o scarica il pdf Manuale per Aspiratore per piscina 8STREME 7310. 8STREME 7310 18. New square swivel
Anche per 8STREME 7310: Manuale (16 pagine), Manuale (3 pagine)
Stampa la pagina
EN
- Check the connection of the floating cable.
Disconnect and reconnect as needed.
- Check the status of the connectors at the ends of
your cables (damaged, rusted, etc.)
- Connection of the floating cable.
- Possibility of fault of the floating cable.
- Possibility of motor leakage.
The robot stops after a few minutes.
The robot moves slower than before.
The blue LED on the "No-Twist" floating device does
not light up ( light C of Chapter 8).
No led lit on the transformer.
The blue light on the No-Twist Floating device is on
but the cleaner does not work ( light C of Chapter 8 ).
The robot leaves traces on the floor or on the walls
- The robot is too heavy.
- The flow is not sufficient.
- Cables connections.
- Bad connection between the transformer and
the No-Twist floating device.
- Possibility of No-Twist floating device problem
- You did not press the on/off button located above
the transformer.
- The current is not reaching the transformer.
- Bad connection between the No-Twist floating
device and the cleaner
- Possibility of No-Twist floating device problem
- Possibility of motor problem.
- State of the brushes and/or transmission belts
- Check that the dirt collecting basket is not full.
- Check and clean if necessary the pump impeller or
the grid above the impeller (propeller at the top
of the robot towards the handle) .
- Check all the cable connections (see chapter 4).
- Turn ON the cleaner by pressing the ON / OFF
button located on top of the transformer.
- Check all the connections of the cables between
the transformer and the No-Twist floating device.
- Contact the After-sales Service
- Check your electrical outlet .
- Check the connections.
- contact our Customer Service.
- Check if the connection at the "No-twist" float
outlet, blue outlet "Pool Cleaner" is correct and
waterproof.
- If the blue light C is on, you should also have a red
light on at the float outlet (light E in Chapter 8).
If this is not the case, it is likely that the float is
defective.
- If both blue and red lights are on but the robot does
not work, please contact your dealer or our
after-sales service at [email protected]
- These brushes and belts are wear-and-tear parts,
Please check them and change them if necessary
Please contact www.8streme.eu if you have any other questions.
PROBLEM
CAUS E(S)
SOLUTION(S)
Page 14