AIRE DECOR BP210-1 Series Manuale di istruzioni per l'installazione - Pagina 6

Sfoglia online o scarica il pdf Manuale di istruzioni per l'installazione per Ventilatore AIRE DECOR BP210-1 Series. AIRE DECOR BP210-1 Series 8.

Stampa la pagina

8. ATTACHING THE FAN

BLADES

Caution: Remove 5 rubber packing mounts and

discard before installation.

Step 1 Attach the blade to the blade bracket using

the screws and fiber washers as shown in Figure

18. Start screw into bracket. Repeat for the two

remaining screws.

Step 2 Tighten each screw. Make sure the blade is

straight.

Step 3 Fasten blade assembly to motor using the

screws supplied. (Fig. 18)

9. INSTALLING THE

LIGHT KIT

(OPTIONAL)

NOTE: Before starting installation, disconnect the

power by turning off the circuit breaker or removing

the fuse at fuse box. Turning power off using the

fan switch is not sufficient to prevent electric shock.

Step 1. Remove the switch housing cover from the

switch housing.

Step 2. Raise and hold the light kit close to the switch

housing and proceed to do the wire connections,

connect the blue wire from the switch housing to the

black wire from the light kit. follow the same procedure

with the black connectors. Use the wire connecting

nuts supplied with your fan. (Fig. 19)

Step 3. Attach the light kit to the switch housing by

using the three (3) screws provided. (Fig. 19)

Screws

Blades bracket

Figure 18

Wire nuts

Switch

housing

Light kit

Figure 19

10. INSTALLING THE

LIGHT BULBS AND

GLASS SHADES

(OPTIONAL)

NOTE: Before starting installation, disconnect the

power by turning off the circuit breaker or removing

the fuse at fuse box.

Turning power off using the fan switch is not

sufficient to prevent electric shock.

Screws

Fiber

1. Insert the glass shades into the light kit with the

washers

thumb screws. (Fig. 20)

Blade

2. Install 40W candelabra bulbs (included).

(Fig. 20)

3. Restore power and your light kit is ready for

operation.

1. Install 60W candelabra bulbs (included).

(Fig. 21)

2. Secure bowl glass to light fitter using supplied

nut. Next install trim cover followed by the finial.

3. Restore power and your light kit is ready for

operation.

Screws

Light kit

Glass shades

Bulbs

Figure 20

Light kit

Glass Bowl

Figure 21

Screws

Bulbs