Dynamite Vision Peak 2 Manuale di istruzioni

Sfoglia online o scarica il pdf Manuale di istruzioni per Caricabatterie Dynamite Vision Peak 2. Dynamite Vision Peak 2 3. Ac/dc peak detection charger

Stampa la pagina

VISION PEAK 2

™

AC/DC Peak Detection Charger

INSTRUCTION MANUAL

Thank you for purchasing the Dynamite

Vision Peak 2 AC/DC Peak Detection

charger. This unique charger allows you to

visually monitor the charge cycle through-

out the charge process. The Vision Peak 2

automatically stops fast charging when the

battery pack is fully charged, protecting

the batteries from damage due to over-

charging. Immediately after the battery

pack has peaked, the charger automatically

transitions to trickle charge. This feature

will allow the battery pack to stay fully

charged until you are ready to use it.

By properly following these instructions,

this charger can provide you with many

years of trouble-free operation.

Vision Peak 2 Features

• Selectable 1-, 2- and 4-amp charge rates

• Charges 4- to 7-cell Ni-Cd and Ni-MH

battery packs

• 110V AC or 12V DC

• LED charge level indicators

• Peak detection circuitry

• Auto-trickle charge

• Heavy-duty 12V DC input alligator clips

• Tamiya-style output (battery) connector

• Voltmeter jacks

• Limited 5-year warranty

• Reciever pack charge lead adapter

Supplying Power to the Charger

This charger can be powered by connecting

it to a 12V DC power source, such as a

12V sealed battery (HAN102) or an auto-

mobile battery. If you choose to power the

charger by connecting it to your automobile

battery, the car must not be running!

AC Power

To power the Vision Peak

™

2 with AC

power, connect the AC power cord into

a standard 110V wall outlet.

DC Power

Attach the red (positive) alligator clip

to the red (positive) terminal on your 12V

DC power source. Next, attach the black

(negative) alligator clip to the black (nega-

tive) terminal.

Caution: Do not use both power

sources simultaneously or damage

will occur.

Charging 4- to 5-Cell Receiver Packs

1. Connect the charger to an input power

source as described previously.

2. Use the included Tamiya to receiver

adapter to connect the battery to

the charger.

3. Select the number of cells in the pack

you are going to charge.

Note: If the number of cells selected

does not match up with the actual

cells in the pack or has a damaged

cell, the charger will stop charging,

and the LEDs will blink.

4. Select the charge rate by pushing the

Start/Select button until the LED

indicates the correct charge rate. Once

the LED is solid, the charger is charging.

Note: When charging packs under

1000mAh, make certain that you

select the 1-amp charge rate. Receiver

packs that have a capacity of 1000mAh

or higher can be charged at 2 amps.

5. Watch the LED continue to climb until

all lights flash, indicating the battery is

fully charged. Once all of the LEDs are

lit and flashing, the charger automatically

transitions to trickle charge.

Charging 6- or 7-Cell Sub C Ni-Cd or

Ni-MH Battery Packs

1. Connect the charger to an input power

source as described previously.

2. Connect the battery to the charger.

3. Select the number of cells in the pack

you are going to charge.

Note: If the number of cells that has

been selected does not match up with

the actual cells in the pack or has a

damaged cell, the charger will stop

charging, and the LEDs will blink.