909 10CSMS Manuale di istruzioni - Pagina 17
Sfoglia online o scarica il pdf Manuale di istruzioni per Sega 909 10CSMS. 909 10CSMS 20. 15 amp 10" 254mm single bevel laser guided slide miter saw
Stampa la paginaBevel cut
A bevel cut is made by
cutting across the grain of
the workpiece with the blade
angled to the fence and miter
table. The miter table is set
at the zero degree position
and the blade set at an angle
between 0º and 45º (Fig. r).
Use the slide action when cutting wide workpieces.
1. Pull on the release knob (5) and lift the saw arm to its
full height.
2. Loosen the miter lock (24).
3. Rotate the miter table (20) until the pointer aligns with
zero on the miter scale (21).
4. Retighten the miter lock (24).
WARNING.
Be sure to tighten the miter lock before making
a cut. Failure to do so could result in the table moving
during the cut, causing serious personal injury.
5. Loosen the bevel lock (15) and pull out the 0º bevel
adjuster. Move the saw arm (4) to the desired bevel angle
(between 0º and 45º). Tighten the bevel lock (15).
6. Place the workpiece flat on the table with one edge
securely against the fence (18). If the board is warped,
place the convex side against the fence. If the concave
side is placed against the fence, the board could break
and jam the blade.
7. When cutting long pieces of timber, support the opposite
end of the timber with the side bars, a roller stand or a
work surface that is level with the saw table.
8. Use the clamp assembly (9) to secure the workpiece
wherever possible.
9. It is possible to remove the clamp assembly (9) by
loosening the clamp assembly lock (10) and moving
it to the other side of the table. Make sure the clamp
assembly lock is tight before using the clamp.
10. Before turning on the saw, perform a dry run of the
r
cutting operation to check that there are no problems.
11. Hold the operating handle (6) firmly and squeeze the
switch trigger (23). Allow the blade to reach maximum
speed.
12. Press the release latch (37) and slowly lower the blade
into and through the workpiece.
13. Release the switch trigger (23) and allow the saw blade
to stop rotating before raising the blade out of the
workpiece. Wait until the blade stops before removing
the workpiece.
Compound miter cut
A compound miter cut involves using a miter angle and
a bevel angle at the same
time (Fig. s). It is used in
making picture frames, to cut
mouldings, making boxes
with sloping sides and for roof
framing. Always make a test
cut on a piece of scrap wood
before cutting into the good
material.
Use the slide action when cutting wide workpieces.
1. Pull on the release knob (5) and lift the saw arm to
its full height.
2. Loosen the miter lock (24).
3. Rotate the miter table (20) until the pointer aligns with the
desired angle on the miter scale (21).
4. Retighten the miter lock (24).
WARNING.
Be sure to tighten the miter lock before making
a cut. Failure to do so could result in the table moving
during the cut, causing serious personal injury.
5. Loosen the bevel lock (15) and pull out the 0º bevel
adjuster and move the saw arm (4) to the left or
right to the desired bevel angle (between 0º and 45º).
Tighten the bevel lock (15).
17
s