909 909210TS Manuale di istruzioni - Pagina 11

Sfoglia online o scarica il pdf Manuale di istruzioni per Sega 909 909210TS. 909 909210TS 18. 1200w 210mm 8" table saw

Fitting and removing the saw blade guard

and dust extractor

1. To remove the guard (8), take off the wing nut and screw,

then lift off the guard.

2. To replace the guard (8), fit it over the riving knife (3) so

that the hole in the guard and the hole in the riving knife

are aligned.

3. Insert the screw and fit the wing nut.

4. Tighten the wing nut sufficiently so that the guard rests

on the table top (1) but will lift when the work piece is

pushed into the blade.

Note.

The blade guard (8) should return to its rest position

after the work piece has been sawn.

5. A vacuum extraction system can be connected to the

outlet of the vacuum extraction.

Note.

If this is the only dust extraction method employed,

seal off the second outlet of the dust extraction.

Note.

A vacuum extraction system such as a household

vacuum cleaner can be connected to the port at the rear of

the blade guard (9).

6. To remove the saw blade guard, proceed in reverse

order.

CAUTION.

The saw blade guard (8) must be in position at

all times to prevent contact with the blade. It should lift up

and onto the work piece when the work piece is passed

through the saw.

Adjusting the fence

Cutting width

1. Use the fence when making longitudinal cuts.

2. The fence can be fitted to either side of the table top (1).

3. Loosen the fence locking knob (6) and slide the fence to

the required side and make sure the metal plates are on

the underside of the table

at both ends.

4. Re-tighten the fence

locking knob (6).