Galaxy 79060702902 Manuale d'uso e manutenzione - Pagina 11

Sfoglia online o scarica il pdf Manuale d'uso e manutenzione per Gamme Galaxy 79060702902. Galaxy 79060702902 14.

Stampa la pagina
General Care & Cleaning
Fig. 1
or
use
a Nail
6_'o_o%_
Fig. 2
J
,
/
Oven Door
Hinge
Fig. 3
Removing
and Replacing
the Oven Door
The door is heavy.
For safe, temporary
storage,
lay the door flat
with the inside of the door facing
down.
To Remove Oven Door:
1.
Open oven door completely (horizontal with floor- See Fig. 1).
2.
Remove 2 screws located on the inside of the oven door liner (See A Fig. 2)
3.
Insertthe 2 screws intothe door hinge holes located on the side of the hinge arm, one
into each hinge (See B Fig. 2).
4.
Close oven door until the door stops, (Do not force the door to close any further). The
placement of these screws should keep door open in about a 45 degree position.
5.
Grasp oven door firmly on both sides and slide door up and off hinges atthe same angle.
(See Fig. 3)
6.
To clean oven door, follow the instructions in the Care & Cleaning
table (page 9).
To Replace Oven Door:
1.
Be sure the hinge arms remain atthe 45 degree angle position. Be surethe screws are
still locking the hinge arms from moving. If the screws fall out of the hinge holes, the
hinge(s) may snap back against the oven frame and could pinch fingers or chip the
porcelain finish on the oven front frame.
2.
Hold door at the sides near the top while resting the lower front of door on your knee.
Insert the door channels at the bottom of door over the door hinges, (See Fig. 3).
3.
AIIowthe door to slide down into the door hinges evenly at the same 45 degree angle.
The hinge arms should be inserted into the bottom corners as far as they can go.
4.
Open door completely (horizontal with floor) and remove both screws from holes in
door hinges.
5.
Reinstall the 2 screws into the door liner (See C Fig. 2).
6.
If the door is not in alignment with the oven frame, remove door and repeat the above
steps.
!'?'_i
iiii:ii::!iii
..........
ilii .......
11