909 PS26W Manuale di istruzioni - Pagina 11
Sfoglia online o scarica il pdf Manuale di istruzioni per Sega 909 PS26W. 909 PS26W 20. 26cc pole trimming saw
Stampa la paginaSetting the oil adjustment screw
The pole saw has an adjustment to vary the oil flow to the
chain. During manufacturing, this has been set to Maximum.
There are 3 settings; Max, Med, and Low. The setting can be
adjusted by:
1. Insert the flat bladed section of the screwdriver supplied
into the head of the oil adjustment screw.
2. Push the screw before attempting to rotate. The screw
will only rotate approx 100 degrees of rotation so do not
attempt to go past these stops.
3. To reduce the oil flow push the screw first and then rotate
clockwise. To increase oil flow (note: Set to maximum),
rotate in an anti-clockwise direction.
Note: Too much oil flow is better than not enough.
Charging the internal battery
(Applicable if you have a Key Start unit only)
The Electric Start pole saw is fitted inside with Nicad
batteries which WILL require a full charge prior to use.
Charge time is 3-5 hours. Do Not leave the battery on
charge for longer than 24 hrs.
Only use the charger supplied
with the pole saw, as detailed in
the specification section of the
manual.
Turn the key to the OFF
•
position and remove the Key.
•
Insert the Plug Pack Charger
into a standard 240V power
point.
Insert the output plug of the
•
plug pack charger into the
charge port side on the pole
saw housing.
Turn on the plug pack
•
charger at the power
point. The red indicator will
illuminate on the side of the charge port indicating the
charger is connected and turned on. Note, the indicator
will remain on all the time the charger is connected and
turned on.
After 5 hours turn off the charger plug pack and remove
•
the plug from the pole saw housing.
Mixing the fuel
MoToR FUEL:
MIX AT 40:1 oNLY
IMPoRTANT. Use good quality air cooled 2-stroke engine oil.
This product is powered by a 2-stroke engine and requires
pre-mixing fuel with 2-stroke oil.
1. Use fresh unleaded petrol.
You must use 2-stroke oil
specifically made for heavily
stressed two-stroke engines.
2. Mix the petrol and oil in an
approved container. Never
mix fuel directly in the line
trimmer fuel tank. Use the
fuel mixing bottle included
with this product.
Note. Mixing has been made easy by including markings
on the container included.
For example, if unleaded fuel is filled to the '400' mark in
the "GAS" column of the container, place oil in the container
until it reaches the next mark (in the 40:1 OIL markings of
the container). Therefore, 400ml of fuel would mean 10ml of
oil must be added.
WARNING.
Never use any type of pre-mixed fuel/oil direct
from fuel stations. This may include special blends intended
for use in mopeds, motorcycles, etc.
3. Mix the fuel thoroughly and also each time before fuelling.
4. Always pre-mix in small quantities. Never mix quantities
larger than what will be used in a 26-day period.
Note.
The mixing bottle provided is NOT for the storage of
fuel. This container is solely for mixing of fuel only.
Ensure to keep this container in a safe storage location,
empty of fuel and out of reach of children.
11
40:1