Galaxy DX-99V Manuale d'uso - Pagina 6

Sfoglia online o scarica il pdf Manuale d'uso per Radio Galaxy DX-99V. Galaxy DX-99V 10. Full channel am/fm/ssb mobile built in frequency counter with roger beep

Stampa la pagina

RF GAIN CONTROL (outer dual concentric): Use to reduce the gain

of the RF amplifier under strong signal conditions.

DIMMER (inner dual concentric): Turns on/off the frequency display,

channel number and the meter lamp. Switch on at minimum brightness;

rotate further to get brighter illumination.

RF POWER (outer dual concentric): This switch is used to select

transmitting power.

ECHO (inner dual concentric): This control is used to echo effect.

TONE (outer dual concentric): This control is used to intervals of echo

sound and VC mode to choose male of female's tone.

CLARIFIER: Allows variation of the receiver operating frequencies

above and below the assigned frequency. Although this control is

intended primarily to tune in SSB signals, it may be used to optimize

AM/FM signals as described in the Operating Procedure paragraphs.

Coarse operates both TX/RX but Fine only in RX.

10. CHANNEL SELECTOR: This switch selects any one of the forty

channels desired. The selected channel appears on the LED readout

directly above the Channel Selector knob.

11. METER: This meter indicates received signal strength, transmitter RF

output power.

12. BAND SWITCH: This switch is used to select Hi or Lo Band selection.

13. BAND SELECTOR: This switch selects A, B, C, D with HI or LOW

band of operation.

14. MODE (PA/FM/AM/USB/LSB): This switch is used to select PA, FM,

AM, LSB or USB mode of operation. Unless the station with which

communication is desired is equipped with SSB, the AM or FM, PA

mode is normally used. The mode selector switch changes the mode of

operation of both transmitter and receiver simultaneously. Turn to

"Receiving SSB Signals" for further explanation of single sideband.

15. ROGER BEEP SWITCH: When this switch is placed in the ROGER

BEEP position, your radio automatically transmits the audio sign at the

end of your transmission. The listener can note easily your transmission

is over through the sign.

- 9 -

16. OFF-NB/NB+ SWITCH: In the NB position, the RF noise blanker is

activated and automatic noise limiter in the audio circuits is also

activated. The RF noise blanker is very effective for repetitive impulse

noise such as ignition interference. If you wish to turn off the frequency

display only set switch to NB+ position.

17. FREQUENCY COUNTER: This frequency counter indicates the

selected frequency counter indicates the selected frequency you wish to

operate on.

18. ECHO/VC/ROBOT: This switch is used to select special sound effects.

For instance, you can transmit your message in a robot tone, echo tone

sounds like in the space and voice changer to change your tone, rotate

the TONE to determine your favorite sound.

19. +10KHz FREQUENCY SHIFT SWITCH: When this switch is

pressed the frequency is shifted 10KHz up. On following channels.

Normal

20. CHANNEL INDICATOR: Numbered LED indicates the selected

channel you wish to operate on.

+10KHz

11A

15A

19A

- 10 -