dbx 160A Manuale di istruzioni - Pagina 13

Sfoglia online o scarica il pdf Manuale di istruzioni per Amplificatore dbx 160A. dbx 160A 20. Compressor limiter
Anche per dbx 160A: Opuscolo e specifiche (2 pagine)

Stampa la pagina

dbx 160A COMPRESSOR / LIMITER

The converse of the above EQ technique may be used: dipping the equalizer bands causes any sound with dominant energy

in the affected register to pull the level up because the 160A will detect a need for less compression.

De-Essing

To apply de-essing to vocals (i.e., a reduction of sibilance), use a parametric equalizer in the level detector circuit and set it

for high frequency boost in the specific frequency range where the vocal "hiss" or lisp occurs (generally in the 4-6kHz

region). This pre-emphasizes the already "hissy" vocal input to the detector. Used in conjunction with a moderate to high

THRESHOLD and COMPRESSION RATIO, this arrangement greatly attenuates the "essing" without affecting the basic

sound quality or balance of the voice. While it is true that all frequencies are lowered in level when the compressor is trig-

gered, generally the "sss" sound occurs alone, before or after the dominant tone in the voice.

Increasing Sustain

To increase the sustain of a musical instrument (e.g., a guitar or bass), use an equalizer in the level detector circuit and

boost the EQ in the dominant frequency range of the instrument. Set the 160A to Hard Knee mode, with a fairly low

THRESHOLD and a moderate COMPRESSION RATIO.

Multi-Way Speaker Systems

If a single compressor is to be used with a multi-way speaker system (i.e., before the crossover, after the EQ), the system

operator is faced with the problem of keeping levels below the point of damage of the most sensitive part of the system. If,

for example, mid-range drivers are frequently damaged, the whole system must be operated at a lower sound-pressure

level, or additional mid-range drivers must be added. By inserting an equalizer in the detector path to the 160A, it can be

made more sensitive to frequencies in the range handled by the sensitive drivers. The system can then be run at higher lev-

els and will only be dropped back when damaging signals are present .

Using a Filter in the Level Detector Circuit

The results of inserting a filter in the level detector circuit are basically the same as obtained with an equalizer, as previ-

ously described. Those frequencies passed by the filter are subject to compression (or at least they are subject to consider-

ably more compression than those frequencies outside the passband). Because a passive filter can have insertion loss, it

may be necessary to lower the 160A's THRESHOLD setting to maintain a given amount of gain reduction within the filter

passband; this can be determined by monitoring the 160A's THRESHOLD LEDs.

Pre-Emphasis for Broadcast Applications

By inserting a pre-emphasis filter network in the detector path of a 160A processing pre-emphasized audio, higher levels

can be run within the headroom limitations of the broadcast chain .

Anticipated Compression (Sidechain Application)

By feeding the program directly to the 160A's detector input and sending the audio signal through a delay line before the

audio input, the unit can anticipate the need for a gain change. With some experimentation, the effect can be that of zero

attack time at a given frequency. Additional signal delays beyond this zero time will then cause the compressor to finish

reducing the gain before the leading edge of the loud passage even enters the signal input. This will suppress the program

material preceding this loud passage. The 160A will then begin to release (recover from compression) before the loud pas-

sage has ended .

160A

INPUT OUTPUT

DETECTOR

INPUT

OUTPUT

DELAY

SOURCE

Figure 5: Anticipated Compresion