Galaxy Galaxy Top mount Manuale d'uso - Pagina 12

Sfoglia online o scarica il pdf Manuale d'uso per Frigorifero Galaxy Galaxy Top mount. Galaxy Galaxy Top mount 17.
Anche per Galaxy Galaxy Top mount: Manuale d'uso e manutenzione (16 pagine)

Stampa la pagina

General Cleaning

(continued)

r _

The door is heavy. For

safe, temporary storage, lay the door

flat with the inside of the door facing

down.

Liftdoorstraightoff 2 door hinges

To Remove

and Replace

Oven

Door

To Remove Oven Door

1. Completely open the oven door.

2. Remove screws located on the inside of the oven door near the hinges

(one on each side).

3. Closethe door to the quarter-open position. Grasp the door firmly on

both sidesand lift up and offthe hinges.

4. To clean oven door, follow the instructions provided in the cleaning chart

under General Cleaning.

To Replace Oven Door

1. Be sure the hinge arms are in the quarter-open

position, Be careful if

pulling the hinges open by hand. The hinges may snap back against the

oven frame and could pinch fingers.

2. Hold the door at the sides near the top. Insert the hinge arms into slots

at the bottom of the door.

3. Hinge arms must go into the range slots evenly. The hinge arms should

be inserted into the bottom corners of the door as far as they can go.

4_ If the door is not in line with the oven frame, remove it and repeat the

above steps.

5. Replace screws previously removed.

Figure 1

Figure 2

To Remove

and

Replace

Oven

Bottom

To Remove Oven Bottom:

1. Remove the oven racks.

2. Remove the two hold-down

screws (Figure 1) at the rear of the oven

bottom panel. If the screws are too tight to remove by hand, use a

screwdriver.

3, To lift out the bottom panel, place fingers in the slots in the bottom.

Lift

the rear of the panel up and back until it is clear of the lip at the front of

the panel (Figure 2).

4. Lift the bottom up and out.

To Replace the Oven Bottom:

1. Place the oven bottom in the oven with the back raised about 6" or until

you can insert the front of the oven bottom

under the hold-down

lip at

the front of the panel.

2. Push the back of the oven bottom

down fully into place on the metal

flanges and insert the hold-down

screws.

Changing

Oven Light

(some models)

Change

the Oven

Light

(some

models)

1. Turn electrical power off at the main source or unplug the range.

2. Replace bulb with a new 40 watt appliance bulb.

3. Turn power back on again at the main source (or plug the range back in).

4. The clock (if equipped)

will then need to be reset. To reset, see Setting

the Clock and Minute

Timer in this Owner's Guide.

Be sure the range is unplugged

and all parts are COOL before

replacing the surface or oven lights. Wear a leather-faced

glove for

protection against possible broken glass.