Autonics FX6Y-I2 Manuale di istruzioni - Pagina 6

Sfoglia online o scarica il pdf Manuale di istruzioni per Strumenti di misura Autonics FX6Y-I2. Autonics FX6Y-I2 6. Din w72xh36mm of counter/timer with indication only

Stampa la pagina

FXY Series

Dot for Decimal Point / Hour. Min. Second

RUN mode

3 sec

RESET

Setting mode

Counter mode

Set decimal point

----

by front

RESET

Proper Usage

● Follow instructions in 'Proper Usage'. Otherwise, It may cause unexpected accidents.

● 24-48VDC, 24VAC power supply should be insulated and limited voltage/current or Class 2, SELV power supply device.

●

Use the product, 0.1 sec after supplying power.

● When supplying or turning off the power, use a switch or etc. to avoid chattering.

● Install a power switch or circuit breaker in the easily accessible place for supplying or disconnecting the power.

●

In case of contact input, set count speed to low speed mode (1cps or 30cps) to operate.

If set to high speed mode (2kcps or 5kcps), counting error occurs due to chattering.

●

Keep away from high voltage lines or power lines to prevent inductive noise.

In case installing power line and input signal line closely, use line filter or varistor at power line and shielded wire at input

signal line.

Do not use near the equipment which generates strong magnetic force or high frequency noise.

●

This product may be used in the following environments.

①Indoors (in the environment condition rated in 'Specifications')

②Altitude max. 2,000m

③Pollution degree 2

④Installation category II

M-72

3 sec

RESET

Timer mode

CLR

Hour, Min, Sec are not divided

with dot.

E.g.) 5959: 59 min 59 sec

※ In run mode, hold the

enters setting mode [DP].

※ In setting mode, hold the

saves the setting and returns to RUN mode.

※ If there is no

setting mode, it returns to RUN mode.

RESET

SET

Hour, Min, Sec are divided with dot.

E.g.) )5(59: 59 min 59 sec

key for over 3 sec, and it

RESET

key for over 3 sec, and it

RESET

key input for 60 sec when entering

RESET