909 LT18V Manuale di istruzioni - Pagina 9
Sfoglia online o scarica il pdf Manuale di istruzioni per Trimmer 909 LT18V. 909 LT18V 20. 20v lithium ion cordless line trimmer
Stampa la paginaWhen recycling, make it non-conductive by applying
•
insulating tape to the terminals located on the battery.
When to charge the battery
New battery packs are shipped in a low charge
condition and must be fully charged before use. It takes
approximately 8 hours to fully charge a new battery and
3-5 hours once the battery has been used in the tool
a few times.
Charging of batteries should not be undertaken casually.
Through the charging cycle the condition of the battery pack
should be monitored and the charge cycle turned
off at completion or at the end of the recommended time.
Accessories
The following accessories are available to use with
this product:
•
20VSPLG: Replacement Spool and Line:
2 X (1.5mm x 4.5m)
•
20V2BATG: 20V Lithium-Ion 2.0Ah Battery
•
20V4BATG: 20V Lthium-Ion 4.0Ah
Extra Run Time Battery
•
20VCHG: 20V Fast Battery Charger
Unpacking
Due to modern mass production techniques, it is unlikely
that your power tool is faulty or that a part is missing.
If you find anything wrong, do not operate the tool
until the parts have been replaced or the fault has been
rectified. Failure to do so could result in serious
personal injury.
Contents of carton
•
1 x Line trimmer
1 x 20V Lithium-ion Battery
•
1 x Battery/Plug Pack Charger
•
1 x Safety guard
•
3 x Screws and washers
•
•
1 x Wheel assembly
1 x Instruction manual
•
9