909 CSS9 Manuale di istruzioni - Pagina 8
Sfoglia online o scarica il pdf Manuale di istruzioni per Sander 909 CSS9. 909 CSS9 11. 160w
Stampa la paginaSwitching on and off
1. With the cordset fitted to a power point, switch the sander
on by pushing the on/off switch (1) downward.
2. To turn off the sander, pull the on/off switch upward.
Fitting sandpaper
1. Disconnect the sander from the power supply.
2. Remove any dust or debris from the hooks and loops of
the platen.
3. If you are using sandpaper
that has dust extraction
holes align the sandpaper
holes with the platen and
press it firmly in place to
ensure a good attachment.
CAUTION.
Take care to
regularly clean out the build up
of dust on the platen
underneath the sandpaper and
not to let the sandpaper wear completely down before
replacing it. Failure to observe these two precautionary
measures can lead to damage to the hooks and loops on
the platen and the sandpaper will not attach properly.
If the platen is damaged, it can be replaced at an authorised
service centre.
Note.
Hook and loop platens are not a warranty item.
Selecting the right grade
of sandpaper for the job
1. Different grades of sanding paper can be purchased from
your local hardware store. Available grades are:
Coarse, Medium and Fine.
2. Use a coarse grit to sand down rough finishes, medium
grit to smooth the work and fine grit to finish off.
3. It is best to make a trial run on a scrap piece of material
to determine the optimum grades of sandpaper for a
particular job.
WARNING.
Do not use the same sanding sheet for wood
and metal. Metal particles become embedded in the
sandpaper and will scour a wooden surface.
WARNING.
Take care to regularly clean out the build up of
dust on the platen underneath the sandpaper and not let
the sandpaper wear completely down before replacing it.
Failure to observe these two precautionary measures can
lead to damage to the platen.
Sanding
1. The sander can be used for most sanding operations
on materials such as wood, plastic, metal and painted
surfaces.
2. Wear safety goggles a dust mask and ear muffs.
3. Switch the sander on whilst it is resting on the
workpiece. Take care to hold the whole area of the
platen on the work.
4. Move the sander over the surface of the work in a
circular motion with an even,
moderate pressure.
5. For a cleaner working
environment you can use
the dust extraction adaptor
(5). The dust extraction
adaptor push fits into the
dust extraction port.
8