Autonics LE4SA Istruzioni - Pagina 9
Sfoglia online o scarica il pdf Istruzioni per Timer Autonics LE4SA. Autonics LE4SA 18. Din w48xh48mm digital backlight lcd timer
Anche per Autonics LE4SA: Manuale (17 pagine)
Stampa la pagina
LE4S Series
● One-shot output time setting
※ Factory default
[Fig.2]
● Time progress UP/DOWN setting
※ Factory default
[Fig.3]
● The minimum input signal setting(LE4S only)
[Fig.4]
※ Factory default
● Output contact setting(LE4SA only)
[Fig.5]
※ Factory default
K-28
When output operation mode ON Delay 2[
1) In function setting mode, if it enter into One-shot output time setting mode as shown in
the [Fig. 2], the last digit will flash.
2) Set One-shot output time using
3) Pressing
key to complete one-shot output time setting and move to the next mode.
4) If pressing
key for 3 sec. in any function setting mode, it will return to Run mode.
1) In function setting mode, if it advances to UP/DOWN setting mode, the characters will be
displayed as shown in the [Fig. 3].
2) Select UP(▲), DN(▼) using
3) Press
key to complete UP/DOWN setting and move to the next mode.
4) If pressing
key for 3sec. in any function setting mode, it will return to Run mode.
RESET, START and INHIBIT.
1) In function setting mode, if it enter into input signal setting mode, the characters will be
displayed as shown in the [Fig. 4].
2) Select 1ms or 20 ms using
3) Press
key to complete input signal width and move to the next mode.
4) If Pressing
key over 3 sec. in any function setting mode, it will return to Run mode.
1) In function setting mode, if it enter into output contact setting mode, the characters will be
displayed as shown in the [Fig. 5].
2)Select time limit 1c+instant limit 1c or time limit 2c using
(Refer to LE4SA Connections on K-20 page for output contact connections)
3) Press
key to complete output contact setting and move to the next mode.
4) If pressing
key for 3 sec. in any function setting, it will return to Run mode.
※ Except for Star-Delta, Twin and Twin 1 modes(2C is set automatically)
※ If pressing
key in Run mode, output contact setting value will be displayed.
(If no key is pressed over 3 sec., it will enter into function setting mode.)
],
ONd2
and
key.(setting range: 0.01s to 99.99s)
,
key.
key
key
,
keys.
key
key
key
key
,
keys.