dynarex 10520 Manuale
Sfoglia online o scarica il pdf Manuale per Apparecchiature mediche dynarex 10520. dynarex 10520 2. Geri chair recliner
Stampa la pagina
Geri Chair
Recliner
Recliner
Manufactured for: Dynarex Corporation
10 Glenshaw Street • Orangeburg, NY 10962
USA • www.dynarex.com
Made in China
Reorder Nos. 10520
10521
10524
10525
1. Slide the 1 piece back assembly (B) into the
10527
10529
2. Raise recliner lock bar (C) to adjust position
3. Insert screws through holes of the horizontal
NOTE: Make sure that the top screw on
both sides of the coated square tubing from
the back assembly are sufficiently secure
before using recliner.
IMPORTANT SAFETY GUIDELINES:
• 10520-10521, 10527 Weight Capacity: 300 lb.
• 10524-10525, 10529 Weight Capacity: 500 lb.
• Caster wheels should be locked during
occupant transfer.
TO PLACE UNIT IN RECLINING POSITION
1. Ensure that recliner lock bar is in stored position.
2. Stand at either side of recliner.
3. Grasp armrest with one hand, and PVC push bar (F) with
4. Push down on push bar to recline the back to the first
5. To raise upright, pull forward on push bar.
6. Set recliner lock bar (C).
ASSEMBLY INSTRUCTIONS
square tubes on the lower frame assembly
(A) so that the holes in the back rest line up
with the holes located on the horizontal brace
of the lower frame assembly (A).
of back assembly (B) until lock-release pull
button (D) positively engages in storage
Holes in Backrest
position.
brace and tighten all screws with screwdriver.
Horizontal Brace
Label Specifying
Date of Manufacturer
RECLINING INSTRUCTIONS
the other hand.
recline position. To achieve second recline position push
on push bar again.
Upholstered Back
Back Assembly (B)
PVC Push
Holes with Screws
Bar (F)
Lock-Release
Pull Button (D)
Holes in
Locking Pins (E)
Recliner Lock
Bar (C)
Lower Frame (A)
Figure 1
RECLINING LOCK OPERATION
To Lock Recliner:
1. Place recliner into desired position.
2. Pull out lock-release pull button (D) to recliner lock bar
(C) from stored position.
3. Rotate recliner lock bar (C) down until notches are fully
engaged over locking pins (E).
To Unlock Recliner:
1. Lift recliner lock bar (C) up to disengage from locking
pins.
2. While holding lock-release pull button (D) out, rotate
recliner lock bar (C) all the way up until completely
against seat back.
3. Release lock-release pull button (D) to hold recliner lock
bar (C) in stored position.
NOTE: Do not attempt to change position of chair with
recliner lock bar engaged. This could cause damage to
mechanism.
NOTE: The table can only be used in upright sitting
position.