DC Pedals 5-Channel Bluetooth Looper Manuale d'uso - Pagina 2

Sfoglia online o scarica il pdf Manuale d'uso per Pedale musicale DC Pedals 5-Channel Bluetooth Looper. DC Pedals 5-Channel Bluetooth Looper 12.

5-Channel Bluetooth Looper

DC Pedals™ 5-Channel Bluetooth Looper

Our 5-Channel Bluetooth Looper is a microcontroller controlled programmable looper effects true-bypass

switching system with five loops, 100 direct accessible presets, 100 MIDI accessible presets, MIDI input and

MIDI output, and our patented Bluetooth wireless programming and control. Use your iOS or Android

mobile device and our VirtualLooper™ app to control and program your looper in real-time. And use the app

off-line to create and manage presets, then download to the looper seconds after setup. The Looper supports

two operational modes, Live Mode and Preset Mode described in the next section of this document.

Operation (Version 5.x Firmware)

The looper operates on 9-18 volts DC. After it completes power-up, it restores itself to how it was set when it

last powered off. It operates in either of two modes described below (Live or Preset Mode). It also supports

a Programming Mode for creating new presets, a Save Mode to save a preset, and a Configuration Mode.

Configuration Mode is used to configure the global preset, MIDI input channel, MIDI output channel, MIDI PC

messages, MIDI CC responses, MIDI through, audio mute, and TRS controls. Programming is accomplished

using the footswitches and can be completed in seconds using just your feet. Programming and real-tine

control can also be done through the VirtualLooper™ mobile app available for Android and iOS.

Presets are arranged in banks and banks are arranged in folders. There are five presets accessible in each

bank. The Bank switch increments the bank from Bank 1 to Bank 5, then back to Bank 1. Twenty-five

presets are quickly accessible via the Bank and Channel switches. There are also four folders that can be

used to organize your presets. Hold the Bank switch 2 seconds and the Looper enters a Folder Select state.

The Looper will blink the currently selected folder LED and light solid the other LEDs, with LED 5 remaining

OFF. Press a Channel switch (switches 1-4) to select a new folder. The Looper will quickly blink the new

Folder LED. Now you have another 25 presets accessible via the Bank and Channel switches.

Firmware Revision Notes

Firmware version number is written on the pcb or chip inside the bypass looper. Firmware updates are

performed by technicians only. Contact us for details.

Revision 5.09 – 12/29/18

•

Added feature to convert Tuner switch to Bank Down switch. Hold the Tuner switch in Preset Mode to

toggle this feature.

•

Added short and long mute times.

•

Changed the mute software to mute only once for each preset change. Previously, the mute would

activate for when toggling each loop.

•

Added notification to the VirtualLooper app when loading global preset.

Revision 5.08 – 10/13/18

•

Fixed an issue during power up with certain power supplies. Looper would not reliably start with

certain power supplies.

Revision 5.07 – Initial release

– User Manual

Page 2 of 12