activTek INDUCT 2000 Manuale d'uso - Pagina 6

Sfoglia online o scarica il pdf Manuale d'uso per Pulitore d'aria activTek INDUCT 2000. activTek INDUCT 2000 16. Electronic air purification system
Anche per activTek INDUCT 2000: Manuale d'uso (9 pagine)

Stampa la pagina

RECOMMENDED INSTALLATION TOOLS

3 1/2" Hole Saw

for wood or metal

(recommended)

11/32" Open-End Wrench

INSTALLATION REquIREMENTS

Installation Requirements

1. Unit should be installed after the air handler in the

HVaC system.

2. The duct work around the installation area should

be clean and dry to insure proper adhesion of the

gasket materials and any tape used.

3. an approximate 3.5" (8.89 cm) opening will need

to be cut into the existing duct work to install the

unit properly.

Electrical Requirements for 120 volt installation only

• To use a 120 volt plug, be sure to locate the unit within 6 ft. of a standard 120 volt

grounded outlet. long term use of an extension cord is not recommended due to

safety considerations.

• Install a US "B" Ua approved plug onto the blunt cord.

Hardwiring Requirements (All units)

• Permanent wiring of the unit into your HVAC system, or installations

using a 120/220 volt, should be done by a licensed HVAC installer or

electrical contractor only.

wARNINg: CHECK SPECIFICATIONS ON LABELINg BEFORE INSTALLINg.

uNIT IS EITHER: 120V, 220V, or DEPENDINg ON MODEL 100-240V.

For 110 volt units: Black = l1, white = Neutral, Green = Ground

For 220 volt units: Black = l1, white = l2, Green = Ground

For International units: Brown = l1, Blue = l2, Green w/yellow stripe = Ground

Drill/Power Driver

1/4" Nut Driver Bit

Phillips Screwdriver

You may also need:

Utility Knife

Min. 8" x 8"

Air

Handler

3/8" Drill Bit

(if installing into fiberglass

ducting with toggle bolts)

Tin Snips

(for metal ductwork)

Max. 6 ft.