activTek INDUCT 2000LV Manuale d'uso - Pagina 6

Sfoglia online o scarica il pdf Manuale d'uso per Pulitore d'aria activTek INDUCT 2000LV. activTek INDUCT 2000LV 17. Electronic air purification system

Stampa la pagina

FIBERGLASS DUCTWORK INSTALLATION

5. Remove backing from mounting plate

adhesive gasket.

7. Insert (4) toggle bolts into 3/8" holes in duct. Be

sure toggle anchors open after inserting.

9. Insert unit into opening. Be sure the air will pass

though the ActivePure® cell honeycomb matrix.

11. Power Connection Requirements: This device is designed for operation from a 24 VAC transformer

typically supplied with straight cool or HVAC systems and can accept a voltage input range of 18-32VAC.

As these transformers also power other circuits, the load capacity of the transformer must be verified prior

to installation to accommodate the maximum combined load requirements of both the device (18 VA)

and all other circuits powered from the transformer. The minimum voltage output from the transformer

under maximum load from all circuits including the device should also meet the minimum voltage input

requirements of each circuit's operational specification including the device. If these conditions cannot be

met, installation of a separate 24 VAC transformer is recommended. Do not connect this unit to any voltage

source above 32 volts. Doing so will cause damage to the unit.

NOTE: Unit requires continuous power. Do not install where power to the unit will be cycled on and off.

(CONTINUED)

Stud

6. Insert (4) 2" Threaded bolts into screw holes at

corners of mounting plate. Attach (4) toggle bolt

anchors to ends of threaded bolts.

8. Center large opening in mounting plate over

3.5" opening in duct and press plate to duct.

The adhesive gasket will hold the mounting

plate into place.

Tighten toggle bolts - DO NOT OVERTIGHTEN.

10. Secure the unit to the mounting plate with (4)

#8-32 nuts.