DCA S1P-FF03-180 Manuale di istruzioni per l'uso - Pagina 6

Sfoglia online o scarica il pdf Manuale di istruzioni per l'uso per Sander DCA S1P-FF03-180. DCA S1P-FF03-180 8.

Auxiliary Handle

Always be sure that the auxiliary

handle is installed securely before

operation.

Screw the auxiliary handle securely

on the position of the tool as shown

in (Fig. 7)

CAUTION:

Always be sure that the tool is switched off and unplugged before carrying out any

work on the tool.

1. Inspecting the mounting screws

Regularly inspect all mounting screws and ensure that they are properly

tightened. Should any of the screws be loose, retighten them immediately.

Failure to do so could result in serious hazard.

2. Maintenance of the motor

The motor unit winding is the very "heart" of the power tool. Exercise due care

to ensure the winding does not become damaged and /or wet with oil or water.

3. Inspecting and replacing the carbon brushes

Remove and check the carbon

brushes regularly. Replace when

they wear down to the limit mark

(6mm or 4 inch) (Fig. 8). Keep the

carbon brushes clean and free to slip

in the holders. Both carbon brushes

should be replaced at the same time.

Use only identical carbon brushes.

-9-

Use a screwdriver to remove the brush

holder caps. Take out the worn carbon

brushes, insert the new ones and secure

the brush holder caps. (Fig. 9)

※ ※ ※ ※ To maintain product SAFETY and RELIABILITY, repairs, any other maintenance or

adjustment should be performed by authorized service centers, always using original

replacement parts.

-10-