Autopage C3-RS-665 Manuale operativo - Pagina 9

Sfoglia online o scarica il pdf Manuale operativo per Avviamento a distanza Autopage C3-RS-665. Autopage C3-RS-665 14. Professional remote car starter & 3 channel security system

Stampa la pagina

To operate the vehicle while running from the remote start.

1. Insert the ignition key and turn it to "ON" (not the start) position.

2. Press the brake pedal.

Note: If the brake p edal is pressed before the key is in the ON

position, the engine will shut down.

TEMPORARY STOP FEATURE:

This feature allows the vehicle to remain running after the key has been

removed from the ignition. This feature is useful for occasions when you

wish to exit and lock the vehicle for short periods of time, but would like to

leave the engine running and the climate control on.

1. Before turning off the engine, press the

transmitter. The parking lights will come on and the LED will f l ash 3

times to confirm Temporary Stop feature 'ON'

2. Turn the ignition key to OFF position. (The engine will stay running.)

3. The engine will run until the pre-programmed time elapsed or shutdown

input is received.

TIMER START:

This unit can be programmed to start and run the engine every 3 hours.

The engine will run for the programmed run time and then shut down.

IMPORTANT: Timer Start should be used only in open areas, Never start

and run the vehicle in on enclosed space as a garage or carport.

3 hours timer start: This feature is design for an extreme cold climate

usage. The system will auto start the vehicle every 3 hours, to prevent

engine freezing and hard to start.

A MAXIMUM OF SIX CYCLES CAN OCCUR.

ENTER:

1. Press the

vehicle is running and the parking lights have turned 'ON'.

2. Immediately press the

parking light will flash (3) times. The siren chirps (3) times. The vehicle

is now programmed to start every (3) hours.

3. Press the brake pedal to stop the vehicle running.

Exit the timer start:

Timer start can be exited manually as follows:

1. Repeat the Enter Steps from above.

1. Make sure the remote start system is not operating the engine.

2. Turn the ignition on. The LED and parking light will flash (4) times. The

horn chirps (4) times.

SHUT-DOWN INPUT FOR REMOTE STARTER:

If any of the following conditions exist while the system is operating, the

engine will not start or will shut down immediately:

button once to remote start the vehicle. As soon as the

button then press

button once on the

button once. The